[U-Boot] [PATCH V5 2/2] MX53: support for freescale MX53LOCO board

[Stefano Babic <sbabic@denx.de>]

On 04/22/2011 10:33 AM, Jason Liu wrote:
> 
> Is there any rule that we need must follow to set the
> CONFIG_SYS_MEMTEST_START
> CONFIG_SYS_MEMTEST_END ??

There is no rule, it was only a question if there are some specific reasons.

> 
> If no, I think the value we set is free. Here I set for 64KB is just
> for simple and quick
> test, there is no other reasons.
> 
> In fact, mtest command line can override the value.

That is correct.

> 
> What the value you think I need set?

As I said, there is no rule. You choose the value you think it is better
for your board as default values for mtest.

Best regards,
Stefano Babic

-- 
=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-0 Fax: +49-8142-66989-80  Email: office at denx.de
=====================================================================