From: Felix Fietkau <nbd@openwrt.org>
To: Gabor Juhos <juhosg@openwrt.org>
Cc: "John W. Linville" <linville@tuxdriver.com>,
linux-wireless@vger.kernel.org,
Luis Rodriguez <Luis.Rodriguez@Atheros.com>,
Vasanthakumar Thiagarajan <vasanth@atheros.com>
Subject: Re: [RFC 20/32] ath9k: set NF limits for AR9330
Date: Wed, 01 Jun 2011 01:03:11 +0200 [thread overview]
Message-ID: <4DE573AF.8060405@openwrt.org> (raw)
In-Reply-To: <1306870643-7935-21-git-send-email-juhosg@openwrt.org>
On 2011-05-31 9:37 PM, Gabor Juhos wrote:
> Signed-off-by: Gabor Juhos<juhosg@openwrt.org>
> ---
> drivers/net/wireless/ath/ath9k/ar9003_phy.c | 5 ++++-
> drivers/net/wireless/ath/ath9k/ar9003_phy.h | 2 ++
> 2 files changed, 6 insertions(+), 1 deletions(-)
>
> diff --git a/drivers/net/wireless/ath/ath9k/ar9003_phy.c b/drivers/net/wireless/ath/ath9k/ar9003_phy.c
> index a0ca1eb..eb18b63 100644
> --- a/drivers/net/wireless/ath/ath9k/ar9003_phy.c
> +++ b/drivers/net/wireless/ath/ath9k/ar9003_phy.c
> @@ -1089,7 +1089,10 @@ static void ar9003_hw_set_nf_limits(struct ath_hw *ah)
> {
> ah->nf_2g.max = AR_PHY_CCA_MAX_GOOD_VAL_9300_2GHZ;
> ah->nf_2g.min = AR_PHY_CCA_MIN_GOOD_VAL_9300_2GHZ;
> - ah->nf_2g.nominal = AR_PHY_CCA_NOM_VAL_9300_2GHZ;
> + if (AR_SREV_9300(ah))
> + ah->nf_2g.nominal = AR_PHY_CCA_NOM_VAL_9330_2GHZ;
Typo in the SREV check?
- Felix
next prev parent reply other threads:[~2011-05-31 23:03 UTC|newest]
Thread overview: 39+ messages / expand[flat|nested] mbox.gz Atom feed top
2011-05-31 19:36 [RFC 00/32] ath9k: add initial support for AR9330 Gabor Juhos
2011-05-31 19:36 ` [RFC 01/32] ath9k: define mac version " Gabor Juhos
2011-05-31 19:36 ` [RFC 02/32] ath9k: define device id " Gabor Juhos
2011-05-31 19:36 ` [RFC 03/32] ath9k: add MAC revision detection " Gabor Juhos
2011-05-31 19:36 ` [RFC 04/32] ath9k: add platform device id " Gabor Juhos
2011-05-31 19:36 ` [RFC 05/32] ath9k: add AR9330 initvals Gabor Juhos
2011-05-31 19:36 ` [RFC 06/32] ath9k: initialize mode registers for AR9330 Gabor Juhos
2011-05-31 19:36 ` [RFC 07/32] ath9k: initialize tx gain table " Gabor Juhos
2011-05-31 19:36 ` [RFC 08/32] ath9k: initialize rx " Gabor Juhos
2011-05-31 19:37 ` [RFC 09/32] ath9k: add AR9330 specific PLL initialization Gabor Juhos
2011-05-31 19:37 ` [RFC 10/32] ath9k: use different BB watchdog timeout value for AR9330 Gabor Juhos
2011-05-31 19:37 ` [RFC 11/32] ath9k: don't enable LDPC " Gabor Juhos
2011-05-31 19:37 ` [RFC 12/32] ath9k: read spur frequency information from eeprom " Gabor Juhos
2011-05-31 19:37 ` [RFC 13/32] ath9k: fix channel frequency calculation for AR9340 Gabor Juhos
2011-05-31 19:37 ` [RFC 14/32] ath9k: configure RF channel frequency for AR9330 Gabor Juhos
2011-05-31 19:37 ` [RFC 15/32] ath9k: enable TX/RX data byte swap " Gabor Juhos
2011-05-31 19:37 ` [RFC 16/32] ath9k: skip internal regulator configuration " Gabor Juhos
2011-05-31 19:37 ` [RFC 17/32] ath9k: enable tuning capacitance " Gabor Juhos
2011-05-31 19:37 ` [RFC 18/32] ath9k: use correct EEPROM base " Gabor Juhos
2011-05-31 19:37 ` [RFC 19/32] ath9k: configure xpa bias level " Gabor Juhos
2011-05-31 19:37 ` [RFC 20/32] ath9k: set NF limits " Gabor Juhos
2011-05-31 23:03 ` Felix Fietkau [this message]
2011-06-01 8:52 ` Gabor Juhos
2011-05-31 19:37 ` [RFC 21/32] ath9k: enable antenna diversity " Gabor Juhos
2011-05-31 19:37 ` [RFC 22/32] ath9k: use correct max_streams " Gabor Juhos
2011-05-31 19:37 ` [RFC 23/32] ath9k: add a missing case statement to ath_ant_div_comb_alt_check Gabor Juhos
2011-05-31 19:37 ` [RFC 24/32] ath9k: fix antenna diversity configuration for non AR9485 chips Gabor Juhos
2011-05-31 19:37 ` [RFC 25/32] ath9k: remove superfluous parentheses Gabor Juhos
2011-05-31 19:37 ` [RFC 26/32] ath9k: add fast_div_bias configuration for diversity group 1 Gabor Juhos
2011-05-31 19:37 ` [RFC 27/32] ath9k: set diversity group for AR9330 Gabor Juhos
2011-05-31 19:37 ` [RFC 28/32] ath9k: fix few register offsets " Gabor Juhos
2011-05-31 19:37 ` [RFC 29/32] ath9k: configure diversity based on eeprom contents " Gabor Juhos
2011-05-31 19:37 ` [RFC 30/32] ath9k: configure internal regulator " Gabor Juhos
2011-05-31 19:37 ` [RFC 31/32] ath9k: add external_reset callback to ath9k_platfom_data " Gabor Juhos
2011-05-31 19:37 ` [RFC 32/32] ath9k: enable support " Gabor Juhos
2011-05-31 19:51 ` [RFC 00/32] ath9k: add initial " Daniel Halperin
2011-06-01 0:46 ` Adrian Chadd
2011-06-01 1:05 ` Daniel Halperin
2011-06-01 1:13 ` Adrian Chadd
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=4DE573AF.8060405@openwrt.org \
--to=nbd@openwrt.org \
--cc=Luis.Rodriguez@Atheros.com \
--cc=juhosg@openwrt.org \
--cc=linux-wireless@vger.kernel.org \
--cc=linville@tuxdriver.com \
--cc=vasanth@atheros.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.