[U-Boot] [PATCH] MX3: make additional hardware and clocks available

[Helmut Raiger <helmut.raiger@hale.at>]

This patch is in preparation for the contribution of our board support. 
More to follow ...

diff --git a/arch/arm/cpu/arm1136/mx31/devices.c 
b/arch/arm/cpu/arm1136/mx31/devices.c
index 1e7d48f..ace48f4 100644
--- a/arch/arm/cpu/arm1136/mx31/devices.c
+++ b/arch/arm/cpu/arm1136/mx31/devices.c
@@ -38,7 +38,21 @@ void mx31_uart1_hw_init(void)
  }
  #endif

+#ifdef CONFIG_SYS_MX31_UART2
+void mx31_uart2_hw_init(void)
+{
+    /* setup pins for UART2 */
+    mx31_gpio_mux(MUX_RXD2__UART2_RXD_MUX);
+    mx31_gpio_mux(MUX_TXD2__UART2_TXD_MUX);
+    mx31_gpio_mux(MUX_RTS2__UART2_RTS_B);
+    mx31_gpio_mux(MUX_CTS2__UART2_CTS_B);
+}
+#endif
+
  #ifdef CONFIG_MXC_SPI
+/* note: putting several spi setups here makes no sense as they may differ
+ * at board level (physical pin SS0 of CSPI2 may aswell be used as SS0 
of CSPI3)
+ */
  void mx31_spi2_hw_init(void)
  {
      /* SPI2 */
diff --git a/arch/arm/cpu/arm1136/mx31/generic.c 
b/arch/arm/cpu/arm1136/mx31/generic.c
index 4ebf38d..92dd8d6 100644
--- a/arch/arm/cpu/arm1136/mx31/generic.c
+++ b/arch/arm/cpu/arm1136/mx31/generic.c
@@ -71,6 +71,18 @@ u32 mx31_get_ipg_clk(void)
      return freq;
  }

+/* hsp is the clock for the ipu */
+u32 mx31_get_hsp_clk(void)
+{
+      u32 freq = mx31_get_mcu_main_clk();
+      u32 pdr0 = __REG(CCM_PDR0);
+
+      /* divided by HSP_PODF in PDR0 */
+      freq /= ((pdr0 >> 11) & 0x7) + 1;
+
+      return freq;
+}
+
  void mx31_dump_clocks(void)
  {
      u32 cpufreq = mx31_get_mcu_main_clk();
diff --git a/arch/arm/include/asm/arch-mx31/clock.h 
b/arch/arm/include/asm/arch-mx31/clock.h
old mode 100644
new mode 100755
index 9f7ae80..980bec1
--- a/arch/arm/include/asm/arch-mx31/clock.h
+++ b/arch/arm/include/asm/arch-mx31/clock.h
@@ -26,10 +26,11 @@

  extern u32 mx31_get_ipg_clk(void);
  #define imx_get_uartclk mx31_get_ipg_clk
+extern u32 mx31_get_hsp_clk(void);
  extern void mx31_gpio_mux(unsigned long mode);
  extern void mx31_set_pad(enum iomux_pins pin, u32 config);
-
  void mx31_uart1_hw_init(void);
+void mx31_uart2_hw_init(void);
  void mx31_spi2_hw_init(void);
  void mxc_hw_watchdog_enable(void);
  void mxc_hw_watchdog_reset(void);
diff --git a/arch/arm/include/asm/arch-mx31/imx-regs.h 
b/arch/arm/include/asm/arch-mx31/imx-regs.h
old mode 100644
new mode 100755
index 306f966..af163cd
--- a/arch/arm/include/asm/arch-mx31/imx-regs.h
+++ b/arch/arm/include/asm/arch-mx31/imx-regs.h
@@ -604,12 +604,41 @@ enum iomux_pins {

  /* Register offsets based on IOMUXC_BASE */
  /* 0x00 .. 0x7b */
+#define MUX_CTL_CSPI3_MISO        0x0c
+#define MUX_CTL_CSPI3_SCLK        0x0d
+#define MUX_CTL_CSPI3_SPI_RDY    0x0e
+#define MUX_CTL_TTM_PAD            0x0f
+#define MUX_CTL_ATA_RESET_B        0x10
+#define MUX_CTL_CE_CONTROL        0x11
+#define MUX_CTL_CLKSS            0x12
+#define MUX_CTL_CSPI3_MOSI        0x13
+
+#define MUX_CTL_SD1_DATA1    0x18
+#define MUX_CTL_SD1_DATA2    0x19
+#define MUX_CTL_SD1_DATA3    0x1a
+#define MUX_CTL_SD1_CMD        0x1d
+#define MUX_CTL_SD1_CLK        0x1e
+#define MUX_CTL_SD1_DATA0    0x1f
+
  #define MUX_CTL_USBH2_DATA1    0x40
  #define MUX_CTL_USBH2_DIR    0x44
  #define MUX_CTL_USBH2_STP    0x45
  #define MUX_CTL_USBH2_NXT    0x46
  #define MUX_CTL_USBH2_DATA0    0x47
  #define MUX_CTL_USBH2_CLK    0x4B
+
+#define MUX_CTL_TXD2        0x70
+#define MUX_CTL_RTS2        0x71
+#define MUX_CTL_CTS2        0x72
+#define MUX_CTL_BATT_LINE    0x73
+#define MUX_CTL_RI_DTE1        0x74
+#define MUX_CTL_DCD_DTE1    0x75
+#define MUX_CTL_DTR_DCE2    0x76
+#define MUX_CTL_RXD2        0x77
+#define MUX_CTL_RI_DCE1        0x78
+#define MUX_CTL_DCD_DCE1    0x79
+#define MUX_CTL_DTR_DTE1    0x7a
+#define MUX_CTL_DSR_DTE1    0x7b
  #define MUX_CTL_RTS1        0x7c
  #define MUX_CTL_CTS1        0x7d
  #define MUX_CTL_DTR_DCE1    0x7e
@@ -667,6 +696,11 @@ enum iomux_pins {
  #define MUX_RTS1__UART1_RTS_B    IOMUX_MODE(MUX_CTL_RTS1, MUX_CTL_FUNC)
  #define MUX_CTS1__UART1_CTS_B    IOMUX_MODE(MUX_CTL_CTS1, MUX_CTL_FUNC)

+#define MUX_RXD2__UART2_RXD_MUX    IOMUX_MODE(MUX_CTL_RXD2, MUX_CTL_FUNC)
+#define MUX_TXD2__UART2_TXD_MUX    IOMUX_MODE(MUX_CTL_TXD2, MUX_CTL_FUNC)
+#define MUX_RTS2__UART2_RTS_B    IOMUX_MODE(MUX_CTL_RTS2, MUX_CTL_FUNC)
+#define MUX_CTS2__UART2_CTS_B    IOMUX_MODE(MUX_CTL_CTS2, MUX_CTL_FUNC)
+
  #define MUX_CSPI2_SS0__CSPI2_SS0_B IOMUX_MODE(MUX_CTL_CSPI2_SS0, 
MUX_CTL_FUNC)
  #define MUX_CSPI2_SS1__CSPI2_SS1_B IOMUX_MODE(MUX_CTL_CSPI2_SS1, 
MUX_CTL_FUNC)
  #define MUX_CSPI2_SS2__CSPI2_SS2_B IOMUX_MODE(MUX_CTL_CSPI2_SS2, 
MUX_CTL_FUNC)
@@ -739,6 +773,10 @@ enum iomux_pins {
   */
  #define NFC_BASE_ADDR    0xB8000000

+/* SD card controller */
+#define SDHC1_BASE_ADDR        0x50004000
+#define SDHC2_BASE_ADDR        0x50008000
+
  /*
   * Internal RAM (16KB)
   */
diff --git a/include/fsl_pmic.h b/include/fsl_pmic.h
old mode 100644
new mode 100755
index e3abde6..e0ef810
--- a/include/fsl_pmic.h
+++ b/include/fsl_pmic.h
@@ -121,6 +121,8 @@ enum {
  /* Interrupt status 1 */
  #define RTCRSTI        (1 << 7)

+struct spi_slave *pmic_spi_probe(void);
+void pmic_spi_free(struct spi_slave *slave);
  void pmic_show_pmic_info(void);
  void pmic_reg_write(u32 reg, u32 value);
  u32 pmic_reg_read(u32 reg);


--
Scanned by MailScanner.