Re: [PATCH] ASoC: Don't use codec->control_data in bulk write

[Liam Girdwood <lrg@ti.com>]

On 13/06/11 18:54, Mark Brown wrote:
> In order to facilitate merging with the register map I/O replace the use
> of control_data for the bulk writes with direct lookup of the client data
> from the device.
> 
> Signed-off-by: Mark Brown <broonie@opensource.wolfsonmicro.com>
> ---
>  sound/soc/soc-io.c |    4 ++--
>  1 files changed, 2 insertions(+), 2 deletions(-)
> 
> diff --git a/sound/soc/soc-io.c b/sound/soc/soc-io.c
> index fbea6c9..cca490c 100644
> --- a/sound/soc/soc-io.c
> +++ b/sound/soc/soc-io.c
> @@ -269,12 +269,12 @@ static int snd_soc_hw_bulk_write_raw(struct snd_soc_codec *codec, unsigned int r
>  	switch (codec->control_type) {
>  #if defined(CONFIG_I2C) || (defined(CONFIG_I2C_MODULE) && defined(MODULE))
>  	case SND_SOC_I2C:
> -		ret = i2c_master_send(codec->control_data, data, len);
> +		ret = i2c_master_send(to_i2c_client(codec->dev), data, len);
>  		break;
>  #endif
>  #if defined(CONFIG_SPI_MASTER)
>  	case SND_SOC_SPI:
> -		ret = spi_write(codec->control_data, data, len);
> +		ret = spi_write(to_spi_device(codec->dev), data, len);
>  		break;
>  #endif
>  	default:

Acked-by: Liam Girdwood <lrg@ti.com>