Re: bridge: HSR support

[Arvid Brodin <arvid.brodin@enea.com>]

Arvid Brodin wrote:
> Stephen Hemminger wrote:
>> On Tue, 11 Oct 2011 20:25:08 +0200
>> Arvid Brodin <arvid.brodin@enea.com> wrote:
>>
>>> Hi,
>>>
>>> I want to add support for HSR ("High-availability Seamless Redundancy",
>>> IEC-62439-3) to the bridge code. With HSR, all connected units have two network
>>> ports and are connected in a ring. All new Ethernet packets are sent on both
>>> ports (or passed through if the current unit is not the originating unit). The
>>> same packet is never passed twice. Non-HSR units are not allowed in the ring.
>>>
>>> This gives instant, reconfiguration-free failover.
>>>
*snip*
> 
> I need to do two things:
> 
> 1) Bind two network interfaces into one (say, eth0 & eth1 => hsr0). Frames sent on
>    hsr0 should get an HSR tag (including the correct EtherType) and go out on both
>    eth0 and eth1.
> 
> 2) Ingress frames on eth0 & eth1, with EtherType 0x88fb, should be captured and 
>    handled specially (either received on hsr0 or forwarded to the other bound 
>    physical interface).
> 
> Any ideas on the best way to implement this -- what's the nicest place to "hook
> into" for this?
> 

Ok, so after a lot of reading and looking through code I have this idea of a
standalone solution:

1) Add ioctls to create (and remove) "hsr" netdevs which encapsulates two
   physical Ethernet interfaces each (somewhat like the bridge code does, but
   with precisely 2 interfaces slaved).

2) Use dev_add_pack() to register protocol ("EtherType") 0x88FB. The device
   that the frames come in on are checked for being a slave to a hsr netdev,
   and handled accordingly.

It would be great to get some input on the sanity of this solution before I get
too much time invested in it!


Thanks,
-- 
Arvid Brodin
Enea Services Stockholm AB