[U-Boot] [PATCH V2] imx: mmc: access mxcmmc from mx31 boards

[Stefano Babic <sbabic@denx.de>]

On 11/07/2011 08:59 AM, Helmut Raiger wrote:
> On 11/02/2011 08:02 AM, Helmut Raiger wrote:
>> On 10/27/2011 02:19 PM, Helmut Raiger wrote:
>>> This patch modifies mxcmmc.c to be used
>>> not only by i.MX27 but also by i.MX31 boards.
>>> Both use the same SD controller, but have different
>>> clock set-ups.
>>> The i.MX27 imx_get_XXXclock functions are made static to
>>> generic.c and a public mxc_get_clock() function
>>> is provided.  Pins, base address and prototypes for
>>> an i.MX31 specific board_init_mmc() are provided.
>>> Some of the i.MX27 clock getters are unused and marked
>>> as such to avoid warnings (./MAKEALL -s mx27), but
>>> the code was left in for future use.
>>>
>>> Signed-off-by: Helmut Raiger<helmut.raiger@hale.at>
>>
>> I just re-titled the patch to make it visible for the imx community,
>> it concerns i.MX27 and i.MX31, so mmc: is probably the wrong
>> category anyway.
>>
>> Helmut

Hi Helmut,

> Anything amiss?
> Helmut

I have seen your message regarding your patch "tt01: add MMC and video
support" asking to ignore it, and I have ignored this patch, too....

I will review it soo - however, there is no use case for MMC on the
i.MX31 until you submit a patch for your board supporting MMC.

Best regards,
Stefano Babic

-- 
=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-0 Fax: +49-8142-66989-80  Email: office at denx.de
=====================================================================