[U-Boot] [PATCH 5/5] mx51evk: Configure the pins as GPIOs prior to using gpio_get_value

[Stefano Babic <sbabic@denx.de>]

On 11/15/2011 04:51 PM, Fabio Estevam wrote:
> Configure the pins as GPIO prior to using gpio_get_value.
>
> Signed-off-by: Fabio Estevam<fabio.estevam@freescale.com>
> ---
>   board/freescale/mx51evk/mx51evk.c |    3 +++
>   1 files changed, 3 insertions(+), 0 deletions(-)
>
> diff --git a/board/freescale/mx51evk/mx51evk.c b/board/freescale/mx51evk/mx51evk.c
> index 37e6e4d..e5b0929 100644
> --- a/board/freescale/mx51evk/mx51evk.c
> +++ b/board/freescale/mx51evk/mx51evk.c
> @@ -265,6 +265,9 @@ int board_mmc_getcd(u8 *cd, struct mmc *mmc)
>   {
>   	struct fsl_esdhc_cfg *cfg = (struct fsl_esdhc_cfg *)mmc->priv;
>
> +	mxc_request_iomux(MX51_PIN_GPIO1_0, IOMUX_CONFIG_ALT1);
> +	mxc_request_iomux(MX51_PIN_GPIO1_6, IOMUX_CONFIG_ALT0);
> +
>   	if (cfg->esdhc_base == MMC_SDHC1_BASE_ADDR)
>   		*cd = gpio_get_value(0);
>   	else

Applied to u-boot-imx, thanks

Best regards,
Stefano Babic

-- 
=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-0 Fax: +49-8142-66989-80  Email: office at denx.de
=====================================================================