Re: Compat-wireless-3.2-rc6-3 is broken for rt2860 device

[Andreas Hartmann <andihartmann@freenet.de>]

Helmut Schaa schrieb:
> Hi,
> 
> Am Mittwoch, 4. Januar 2012, 09:38:02 schrieb Andreas Hartmann:
>> Helmut Schaa schrieb:
>>>> Removing this patch
>>>>
>>>> mac80211: retry sending failed BAR frames later instead of tearing down
>>>> aggr (http://www.spinics.net/lists/linux-wireless/msg76379.html) makes
>>>> it working again.
>>>>
>>>> Device is: RaLink RT2800 802.11n PCI
>>>
>>> What's the client device connected to the rt2x00 AP?
>>
>> It's a rt3572 usb chip (Linksys WUSB600N v2), driven with the rt3572sta
>> module.
>>
>>> Mind to send a
>>> 802.11 capture wen this stall happens?
> 
> Andreas provided me with a capture now. The interesting part is that
> the rt2x00 AP sends bursts of BARs with the same sequence number when
> the stall happens. I only had a quick look at the code in question but
> couldn't see anything wrong at a first glance.


Some additional information:

- The AP initiates BARs for 6 different, successive sequence numbers.
- The first 5 sequence numbers are finished after sending of about 8 (!)
BAR's.
Important: each BAR is responded *instantly* by the STA.
- The BAR for the next sequence number is sent "endless" though the STA
responses to each BAR instantly again.


Another thing: it is striking, that the performance from STA -> AP is at
max 8,5 MBit/s, whereas the performance from AP -> STA can be 15 MBit/s
(all measured with netperf).


Could it be, that somewhere in the stack of the AP the response packet
from STA -> AP get's lost or ignored or blocked?



Kind regards,
Andreas