Re: stmmac: fix phy naming inconsistency

[Florian Fainelli <florian@openwrt.org>]

Hello Alessandro,

On 01/24/12 10:26, Alessandro Rubini wrote:
> After commit "db8857b stmmac: use an unique MDIO bus name" my
> device stopped being probed because two different names were being
> used in different places. This fixes the inconsistency.
>
> Signed-off-by: Alessandro Rubini<rubini@gnudd.com>
> Acked-by: Giancarlo Asnaghi<giancarlo.asnaghi@st.com>
> Cc: Giuseppe Cavallaro<peppe.cavallaro@st.com>
> Cc: Florian Fainelli<florian@openwrt.org>

Acked-by: Florian Fainelli <florian@openwrt.org>

> ---
>
> Before the commit, the phy was identified like this and stuff worked:
>
>       PHY ID 20005c90 at 1 IRQ 0 (506:01) active
>
> After that commit, I get
>
>       PHY ID 20005c90 at 1 IRQ 0 (STMMAC MII Bus-1:01) active
>       PHY stmmac-1:01 not found
>
> In one place, "stmmac" is a static string, on the other the commit
> used the name field of the bus that was "STMMAC MII Bus", so I changed
> this older string to be nicer -- without spaces.
>
> Maybe the name is available where "stmmac" is spelled out, but I
> didn't check.
>
> Now it works for me:
>
>      eth1: PHY ID 20005c90 at 1 IRQ 0 (stmmac-1:01) active
>      PHY: stmmac-1:01 - Link is Up - 100/Full
>
>
>   drivers/net/ethernet/stmicro/stmmac/stmmac_mdio.c |    2 +-
>   1 files changed, 1 insertions(+), 1 deletions(-)
>
> diff --git a/drivers/net/ethernet/stmicro/stmmac/stmmac_mdio.c b/drivers/net/ethernet/stmicro/stmmac/stmmac_mdio.c
> index 6e712c5..819606e 100644
> --- a/drivers/net/ethernet/stmicro/stmmac/stmmac_mdio.c
> +++ b/drivers/net/ethernet/stmicro/stmmac/stmmac_mdio.c
> @@ -154,7 +154,7 @@ int stmmac_mdio_register(struct net_device *ndev)
>   	else
>   		irqlist = priv->mii_irq;
>
> -	new_bus->name = "STMMAC MII Bus";
> +	new_bus->name = "stmmac";
>   	new_bus->read =&stmmac_mdio_read;
>   	new_bus->write =&stmmac_mdio_write;
>   	new_bus->reset =&stmmac_mdio_reset;