Re: [PATCH] stmmac: Use correct MDIO bus name so that phy_connect() works again

[Florian Fainelli <florian@openwrt.org>]

On 01/26/12 15:46, Stefan Roese wrote:
> Patch db8857bf [stmmac: use an unique MDIO bus name.] changed the
> MDIO bus name. After this phy_connect() fails. This patch changes
> the bus name in stmmac_mdio.c so that the name matching works
> again.

Alessandro already proposed such a patch: 
http://patchwork.ozlabs.org/patch/137531/
which has been applied by David already.

>
> Signed-off-by: Stefan Roese<sr@denx.de>
> Cc: Florian Fainelli<florian@openwrt.org>
> Cc: Giuseppe Cavallaro<peppe.cavallaro@st.com>
> ---
>   drivers/net/ethernet/stmicro/stmmac/stmmac_mdio.c |    2 +-
>   1 files changed, 1 insertions(+), 1 deletions(-)
>
> diff --git a/drivers/net/ethernet/stmicro/stmmac/stmmac_mdio.c b/drivers/net/ethernet/stmicro/stmmac/stmmac_mdio.c
> index da4a104..7319532 100644
> --- a/drivers/net/ethernet/stmicro/stmmac/stmmac_mdio.c
> +++ b/drivers/net/ethernet/stmicro/stmmac/stmmac_mdio.c
> @@ -154,7 +154,7 @@ int stmmac_mdio_register(struct net_device *ndev)
>   	else
>   		irqlist = priv->mii_irq;
>
> -	new_bus->name = "STMMAC MII Bus";
> +	new_bus->name = "stmmac";
>   	new_bus->read =&stmmac_mdio_read;
>   	new_bus->write =&stmmac_mdio_write;
>   	new_bus->reset =&stmmac_mdio_reset;