[U-Boot] [PATCH 8/8] microblaze: ll_temac: export xilinx_ll_temac_eth_init() for evaluation

[Michal Simek <monstr@monstr.eu>]

Stephan Linz wrote:
> Signed-off-by: Stephan Linz <linz@li-pro.net>
> ---
>  .../xilinx/microblaze-generic/microblaze-generic.c |   57 ++++++++++++++++++++
>  drivers/net/xilinx_ll_temac.c                      |    2 +-
>  include/xilinx_ll_temac.h                          |    3 +
>  3 files changed, 61 insertions(+), 1 deletions(-)
> 
> diff --git a/board/xilinx/microblaze-generic/microblaze-generic.c b/board/xilinx/microblaze-generic/microblaze-generic.c
> index 517b2f1..d2f56b9 100644
> --- a/board/xilinx/microblaze-generic/microblaze-generic.c
> +++ b/board/xilinx/microblaze-generic/microblaze-generic.c
> @@ -31,6 +31,10 @@
>  #include <asm/microblaze_intc.h>
>  #include <asm/asm.h>
>  
> +#ifdef CONFIG_XILINX_LL_TEMAC
> +#include <xilinx_ll_temac.h>
> +#endif
> +
>  int do_reset(cmd_tbl_t *cmdtp, int flag, int argc, char * const argv[])
>  {
>  #ifdef CONFIG_SYS_GPIO_0
> @@ -92,7 +96,60 @@ int board_eth_init(bd_t *bis)
>  #endif
>  
>  #ifdef CONFIG_XILINX_LL_TEMAC
> +#if 1
> +	/* This should be the preferred way to initialize
> +	 * all the interfaces. */
>  	ret |= xilinx_ll_temac_standard_init(bis);

if 1 is not the best for mainline because it means that below is dead code.

Michal

-- 
Michal Simek, Ing. (M.Eng)
w: www.monstr.eu p: +42-0-721842854
Maintainer of Linux kernel 2.6 Microblaze Linux - http://www.monstr.eu/fdt/
Microblaze U-BOOT custodian