From mboxrd@z Thu Jan 1 00:00:00 1970 From: Lee Burchett Date: Thu, 23 Feb 2012 14:44:11 +0000 Subject: Re: [lm-sensors] Nuvoton W83677HG-I/W83676HG-I Message-Id: <4F4650BB.4020201@gmail.com> List-Id: References: <4F45B3ED.7080701@gmail.com> In-Reply-To: <4F45B3ED.7080701@gmail.com> MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: lm-sensors@vger.kernel.org Guenter, I downloaded and installed the driver last night. The file I picked up was groeck-w83627ehf-dof3594.tar.gz. It appeared to build and install alright. I am using Kernel 3.0.0-16-generic on a x64 Ubuntu 11.10 distribution. After running make-install, I ran sensors-detect again and I still got this message: Now follows a summary of the probes I have just done. Just press ENTER to continue: Driver `adt7475': * Bus `NVIDIA i2c adapter 2 at 1:00.0' Busdriver `nvidia', I2C address 0x2e Chip `Analog Devices ADT7473' (confidence: 5) Driver `to-be-written': * ISA bus, address 0x290 Chip `Nuvoton W83677HG-I (NCT6771F/NCT6772F/NCT6775F) Super IO Sensors' (confidence: 9) Note: there is no driver for Nuvoton W83677HG-I (NCT6771F/NCT6772F/NCT6775F) Super IO Sensors yet. Check http://www.lm-sensors.org/wiki/Devices for updates. To load everything that is needed, add this to /etc/modules: #----cut here---- # Chip drivers adt7475 #----cut here---- If you have some drivers built into your kernel, the list above will contain too many modules. Skip the appropriate ones! I am using an older version of sensors-detect. I will update that as well, and let you know what happens. Any other thoughts on what I should do? Lee Burchett zaknafien13@gmail.com On 02/22/2012 11:06 PM, Guenter Roeck wrote: > On Wed, Feb 22, 2012 at 10:35:09PM -0500, Lee Burchett wrote: >> I have an ASRock board that uses a newer Nuvoton W83677HG-I Super I/O >> chip. I would like to help develop (or get help developing) a set of >> drivers for this chip. It is similar to previous versions of Nuvoton >> chips like the W83627 series. I found the sensor drivers from Guenter >> Roeck (Thank You) that are intended for the W83627 series. I was hoping >> to build on these, but I don't know enough about how kernel modules work >> to proceed. >> >> The manufacturer was helpful in providing documentation for this chip, >> the W83627UHG, and the W83627DHG-P. Comparing the devices, I noticed >> that many of the data formats and I/O methods are the same, So I hope >> that my new chip can be added in fairly easily. >> > W83677HG-I and NCT6775F are the same. Did you try the existing driver ? > > Thanks, > Guenter _______________________________________________ lm-sensors mailing list lm-sensors@lm-sensors.org http://lists.lm-sensors.org/mailman/listinfo/lm-sensors