Re: [PATCH 03/10] stmmac: sanitize the rx coe and add the type-1 csum

[deepaksi <deepak.sikri@st.com>]

On 4/2/2012 4:37 PM, Giuseppe CAVALLARO wrote:
> On 3/24/2012 10:21 AM, Deepak SIKRI wrote:
>>
>>
>> On 3/23/2012 2:38 PM, Giuseppe CAVALLARO wrote:
>>> [snip]
>>>
>>>
>>> -    priv->rx_coe = priv->hw->mac->rx_coe(priv->ioaddr);
>>> -    if (priv->rx_coe)
>>> -        pr_info(" RX Checksum Offload Engine supported\n");
>>> +    if (priv->plat->rx_coe)
>>> +        pr_info(" RX Checksum Offload Engine supported (type %d)\n",
>>> +            priv->plat->rx_coe);
>>>        if (priv->plat->tx_coe)
>>>            pr_info(" TX Checksum insertion supported\n");
>>>
>> rx_coe needs to be enabled. Earlier it was being done. Any specific
>> reasons to remove this.
>> Instead this code needs to be moved post mac reset has been done.
> Hello Deepak
>
> sorry for this delay.
>
> I've not clear at all your question.
> The driver well uses the rx_coe as briefly described below:
>
> probe funct
>    |__ hw_init
>           |_ check the RX type from HW cap reg
>                   |__ Override the rx_coe if required
>
> After that the rx_coe is used and passed to the core as expected.
> In case of there is no HW cap register so the rx_coe from platform will
> be used.
>
> Peppe

In the same patch, this portion of the code has been removed.

-static int dwmac1000_rx_coe_supported(void __iomem *ioaddr)
-{
-	u32 value = readl(ioaddr + GMAC_CONTROL);
-
-	value |= GMAC_CONTROL_IPC;
-	writel(value, ioaddr + GMAC_CONTROL);
-
-	value = readl(ioaddr + GMAC_CONTROL);
-
-	return !!(value&  GMAC_CONTROL_IPC);
-}

Earlier this was taking care of setting the IP Checksum offloading feature
in case its available. This code has to be present, as I do not see any
other location where the IPC bit is being programmed.

Also, the location of setting the IPC should be post the mac has been reset.

I hope this clears the things a bit. Sorry for the miscommunication.

Rgds
Deepak






>> Regards
>> Deepak
>>
> .
>