Re: [Xenomai-help] Understanding the output of hackbench when run together with xeno-test

[Gilles Chanteperdrix <gilles.chanteperdrix@xenomai.org>]

On 04/17/2012 01:30 PM, Gilles Chanteperdrix wrote:
> On 04/17/2012 01:11 PM, Anisha Kaul wrote:
>> Greetings,
>>
>> The hackbench command I issued is as follows: _______________________________
>>
>> /usr/xenomai/bin/xeno-test -l "dohell -b ./hackbench -pipe 100 process 100"
> 
> You do not use dohell properly. The syntax for running dohell is
> detailed below
> 
>> /usr/xenomai/bin/dohell [ -b path ] [ -s server ] [ -p port ] [ -m
>> mntpoint ] [ -l path | seconds ]
>>
>> Generate load, using an assorted set of commands and optionnaly:
>> - hackbench if the path to the hackbench binary is specified with -b;
>> - nc to send TCP data to "server" port "port" if -s is specified (if -p
>> is not specified, the port 9, aka discard is used);
>> - dd to write data under "mntpoint" if -m is specified.
>>
>> during the runtime of the LTP test if the path to the LTP installation
>> directory is specifed with -l or during "seconds" seconds.
> 

Ok, it is not clear: but you need to pass a duration if you do not pass
the patch to LTP, which means either the "-l path" or "seconds" argument
is mandatory.

-- 
                                                                Gilles.