[U-Boot] [PATCH] i.mx: i.mx6x: NO_MUX_I/NO_PAD_I not set correctly

[Stefano Babic <sbabic@denx.de>]

On 11/04/2012 13:18, Jason Liu wrote:
> If one PAD does not have mux or pad config register, we need
> set the NO_MUX_I/NO_PAD_I to 0, the old value is not correct
> 
> Signed-off-by: Jason Liu <jason.hui@linaro.org>
> CC: Stefano Babic <sbabic@denx.de>
> ---
>  arch/arm/include/asm/arch-mx6/mx6x_pins.h |    4 ++--
>  1 files changed, 2 insertions(+), 2 deletions(-)
> 
> diff --git a/arch/arm/include/asm/arch-mx6/mx6x_pins.h b/arch/arm/include/asm/arch-mx6/mx6x_pins.h
> index afaa068..9979651 100644
> --- a/arch/arm/include/asm/arch-mx6/mx6x_pins.h
> +++ b/arch/arm/include/asm/arch-mx6/mx6x_pins.h
> @@ -48,8 +48,8 @@
>  #define PAD_CTL_SRE_FAST	(1 << 0)
>  #define PAD_CTL_SRE_SLOW	(0 << 0)
>  
> -#define NO_MUX_I		0x3FF
> -#define NO_PAD_I		0x7FF
> +#define NO_MUX_I                0
> +#define NO_PAD_I                0
>  
>  enum {
>  	MX6Q_PAD_SD2_DAT1__USDHC2_DAT1		= IOMUX_PAD(0x0360, 0x004C, 0, 0x0000, 0, 0),

Applied to u-boot-imx, thanks. Sorry that it was not applied before ;-)

Best regards,
Stefano Babic

-- 
=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de
=====================================================================