[U-Boot] Building u-boot for iMX28 and getting error in mkimage of missing command line parameter CONFIG_IMX_CONFIG

[Bill <bsousan@techsi.com>]

Thanks.  I tried that and got the same results.  Are there any 
debug/logging that I can use to see what's going on?

Also, I'm not sure which console parameters are passed to the kernel.  
I've seen console,  console_mainline, console_fsl, etc...   Which one is 
actually passed as command line params to the kernel?

Thanks,
Bill


On 7/27/2012 8:11 AM, Fabio Estevam wrote:
> Bill,
>
> On Fri, Jul 27, 2012 at 10:07 AM, Bill<bsousan@techsi.com>  wrote:
>> Thanks.  That did it!
>>
>>
>> However, now my new U-boot built from the mainstream Uboot runs and also
>> loads and unpacks the Linux kernel - but it dies after that.  However, my
>> original U-boot from tlib works fine.  Are there some patches and/or
>> settings I am missing?
> I suppose you are using the 2.6.35 kernel. In this FSL kernel the
> console is ttyAM0.
>
> In mainline kernel the console is ttyAMA0.
>
> This is probably the reason you don't see nothing in the console.
>
> I would suggest you to use the mainline kernel though.
>
> Regards,
>
> Fabio Estevam

-- 
William (Bill) L. Sousan, Ph.D.
(w) 402.331.4977 ext. 4002
bsousan at techsi.com
Technical Support Inc.
11253 John Galt Blvd
Omaha, NE 68137
www.techsi.com
8(a) SDB Certified, ISO 9001:2008