[U-Boot] [PATCH] mx53loco: Define CONFIG_BOARD_LATE_INIT

[Stefano Babic <sbabic@denx.de>]

On 31/07/2012 21:21, Fabio Estevam wrote:
> Define CONFIG_BOARD_LATE_INIT so that the serial console messages can be redirected to the serial port.
> 
> This is needed because in mx53loco.c we have:
> 
> #ifdef CONFIG_BOARD_LATE_INIT
> int board_late_init(void)
> {
> 	setenv("stdout", "serial");
> 
> 	return 0;
> }
> #endif
> 
> Signed-off-by: Fabio Estevam <fabio.estevam@freescale.com>
> ---
>  include/configs/mx53loco.h |    1 +
>  1 files changed, 1 insertions(+), 0 deletions(-)
> 
> diff --git a/include/configs/mx53loco.h b/include/configs/mx53loco.h
> index 0a25c7d..bd23387 100644
> --- a/include/configs/mx53loco.h
> +++ b/include/configs/mx53loco.h
> @@ -41,6 +41,7 @@
>  #define CONFIG_SYS_MALLOC_LEN		(10 * 1024 * 1024)
>  
>  #define CONFIG_BOARD_EARLY_INIT_F
> +#define CONFIG_BOARD_LATE_INIT


Applied to u-boot-imx, thank.

This is a real fix - board does not run without it. According to our
discussion in the thread, dropping setenv("stdout", "serial") in code
should be done in a separate patch.

Best regards,
Stefano Babic

-- 
=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de
=====================================================================