Re: Re : BLE -Multiple connection

[Ajay KV <ajay.kv@globaledgesoft.com>]

On 08/22/2012 12:01 PM, Anderson Lizardo wrote:
> Hi Ajay,
>
> On Wed, Aug 22, 2012 at 7:18 PM, Ajay KV<ajay.kv@globaledgesoft.com>  wrote:
>>          First of all, sorry for my ignorance . Following are the steps i did
>> in my test case.  i am also using dual mode dongles , so as you said  spec
>> is not allowing us to do  this operation
>> [snip]
>
> I remembered that the Core spec mentions that it is not required for a
> controller to support more than one connection. Maybe it is the case
> for the dongles you have? In this case, the controller will not allow
> to send connectable advertising because of the active connection.
>
> (sorry, I could not find the section of the spec that mentions this)
>
> If you close the connection, are you able to run "hciconfig hci0
> leadv" again on "A"?
>
> Regards,


Hi ,

	yes , exactly the moment the connection get terminates ,  i could able 
to enable advertise again. The intresting point is that during connected 
mode , even advertise disable  is also giving the same "command 
disallowed" error.

regards