Re: [PATCH] omap-i2c: fix incorrect log message when using a device tree

[Florian Vaussard <florian.vaussard-p8DiymsW2f8@public.gmane.org>]

Hello Wolfram,

>> When booting using a device tree, the adapter number is dynamically
>> assigned after the log message is sent.
>> This patch modifies the log message to get a correct adapter id.
>>
>> Applies on 3.6-rc3. Tested on OMAP3 (Gumstix Overo).
>
> Thanks for the fix. Tested successfully on OMAP4 SDP DT boot as well.
>
> [    0.000000] Linux version 3.6.0-rc3-00030-g491038d (bcousson@lnwes3201) (gcc version 4.5.2 (Sourcery G++ Lite 2011.03-41) ) #6 SMP Fri Aug 31 13:50:48 CEST 2012
> [    0.000000] CPU: ARMv7 Processor [411fc092] revision 2 (ARMv7), cr=10c53c7d
> [    0.000000] CPU: PIPT / VIPT nonaliasing data cache, VIPT aliasing instruction cache
> [    0.000000] Machine: Generic OMAP4 (Flattened Device Tree), model: TI OMAP4 SDP board
> ...
> [    0.667205] omap_i2c i2c.15: bus 0 rev2.4.0 at 400 kHz
> ...
> [    0.768341] omap_i2c i2c.16: bus 1 rev2.4.0 at 400 kHz
> [    0.783905] omap_i2c i2c.17: bus 2 rev2.4.0 at 400 kHz
> [    0.799530] omap_i2c i2c.18: bus 3 rev2.4.0 at 400 kHz
>
>
>> Signed-off-by: Florian Vaussard <florian.vaussard-p8DiymsW2f8@public.gmane.org>
>
> Tested-by: Benoit Cousson <b-cousson-l0cyMroinI0@public.gmane.org>
> and
> Acked-by: Benoit Cousson <b-cousson-l0cyMroinI0@public.gmane.org>
>
> Regards,
> Benoit
>

Was this patch picked-up by the i2c-embedded subsystem?

Thank you.

Regards,
Florian