Re: pandaboard not booting

[Radu Moisan <radu.moisan@intel.com>]

[-- Attachment #1: Type: text/plain, Size: 1874 bytes --]

Hi Enrico,
I'm not sure what are you reffering to when you say bootloader env, but 
here's what I get on my console:

U-Boot SPL 2011.12-dirty (Sep 24 2012 - 17:18:42)
Texas Instruments OMAP4430 ES2.3
Bypassing DPLL failed 4a008180
OMAP SD/MMC: 0
reading u-boot.img
reading u-boot.img


U-Boot 2011.12-dirty (Sep 24 2012 - 17:18:42)

CPU  : OMAP4430 ES2.3
Board: OMAP4 Panda
I2C:   ready
DRAM:  1 GiB
MMC:   OMAP SD/MMC: 0
Using default environment

In:    serial
Out:   serial
Err:   serial
Hit any key to stop autoboot:  0
reading boot.scr

** Unable to read "boot.scr" from mmc 0:1 **
reading uImage

4176612 bytes read
Booting from mmc0 ...
## Booting kernel from Legacy Image at 82000000 ...
    Image Name:   Linux-3.1.0
    Image Type:   ARM Linux Kernel Image (uncompressed)
    Data Size:    4176548 Bytes = 4 MiB
    Load Address: 80008000
    Entry Point:  80008000
    Verifying Checksum ... OK
    Loading Kernel Image ... OK
OK

Starting kernel ...

Uncompressing Linux... done, booting the kernel.

All I did to build it, was to add meta-ti to my bblayers.conf and try 
bitbake with MACHINE=pandaboard. The build was screaming about some QA 
errors, which I had to disable to get the build finish. I'm assuming 
those are the reason for my failure. However, I did not investigate 
further into these.

Thanks,
Radu

On 09/26/2012 12:20 PM, Enrico wrote:
> On Wed, Sep 26, 2012 at 10:02 AM, Radu Moisan <radu.moisan@intel.com> wrote:
>> Hi guys,
>> Can anyone tell me if pandaboard is working with master branch of poky? I
>> just don't want to waste my time figuring out what I've done wrong, if the
>> build is not working anyway.
> It's a long time since i tried it but it was working, can you post
> your bootloader env? Maybe you are just missing the console=ttyO2...
> part.
>
> Enrico


[-- Attachment #2: Type: text/html, Size: 4081 bytes --]