[U-Boot] [PATCH v2 0/7] mtd/st_smi: Add fixes for smi driver

[Vipin Kumar <vipin.kumar@st.com>]

Hello Stefan,

As you can see, I have added your Acked-by to patches 2, 3, 4, 6
The reset are still pending. If you can quickly close them, I can send a 
pull-request for these patches

Thanks for a fast review

Regards
Vipin

On 12/6/2012 2:17 PM, Vipin KUMAR wrote:
> Modifications in v2 (Review comments incorporation)
> - Use setbits_le32 and clrbits_le32 whereever applicable in patch-set
> - Define smi_mtd_init() routine irrespective of CONFIG_MTD_DEVICE
>
> Modifications in v1
> - Add MTD support for smi driver
> - Write to flash in a tight loop
> - Alphabetically sort the list of devices
> - Avoid issuing multiple write enable commands
>
> Armando Visconti (1):
>    mtd/st_smi: Add support for Micron N25Q128 Flash
>
> Vipin Kumar (6):
>    mtd/st_smi: Clear error flags while initiating a fresh write
>    mtd/st_smi: Rearrange the supported devices in alphabetical order
>    mtd/st_smi: Avoid issuing multiple WE commands
>    mtd/st_smi: Write to flash in a tight loop
>    mtd/st_smi: Use page sizes respective to flash
>    mtd/st_smi: Add mtd support for smi
>
>   drivers/mtd/st_smi.c       | 260 ++++++++++++++++++++++++++++++++++++++-------
>   include/linux/mtd/st_smi.h |   1 -
>   2 files changed, 223 insertions(+), 38 deletions(-)
>