Re: WARNING: at net/wireless/mlme.c:517

[Larry Finger <Larry.Finger@lwfinger.net>]

On 01/01/2013 08:45 AM, Julian Wollrath wrote:
> Hello,
>
> while trying to connect to an AP I got the following trace:
> [  436.155474] rtl8192ce 0000:01:00.0 wlan0: disabling HT/VHT due to
> WEP/TKIP use [  436.155492] rtl8192ce 0000:01:00.0 wlan0: disabling HT
> as WMM/QoS is not supported by the AP [  436.155499] rtl8192ce
> 0000:01:00.0 wlan0: disabling VHT as WMM/QoS is not supported by the AP

The above are informative, and are letting you know that your AP is not capable 
of supporting the highest throughput.

> [  436.155998] wlan0: associate with xx:xx:xx:xx:xx:xx (try 1/3)
> [  436.158343] wlan0: RX AssocResp from xx:xx:xx:xx:xx:xx (capab=0x411
> status=0 aid=4) [  436.158478] wlan0: associated [  436.158538] IPv6:
> ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready [  446.153705]
> ------------[ cut here ]------------ [  446.153765] WARNING: at
> net/wireless/mlme.c:517 cfg80211_mlme_disassoc+0x17d/0x190 [cfg80211]()

This one indicates that there was a call to disassociate when the device was not 
associated. It might have been informative to have seen the logged messages 
earlier than 436.155474 seconds.

Johannes: Why is this a WARN_ON condition? Certainly, the returned -ENOTCON does 
the right thing, even though some part of the system got confused.

Larry