[U-Boot] [PATCH] mx35pdk:Use IMX_GPIO_NR macro

[Stefano Babic <sbabic@denx.de>]

On 07/11/2012 18:37, Ashok Kumar Reddy wrote:
> Use IMX_GPO_NR macro
> 
> Signed-off-by: Ashok Kumar Reddy <ashokkourla2000@gmail.com>
> ---
>  board/freescale/mx35pdk/mx35pdk.c |    2 +-
>  1 file changed, 1 insertion(+), 1 deletion(-)
> 
> diff --git a/board/freescale/mx35pdk/mx35pdk.c b/board/freescale/mx35pdk/mx35pdk.c
> index 7cb6b30..e9b3827 100644
> --- a/board/freescale/mx35pdk/mx35pdk.c
> +++ b/board/freescale/mx35pdk/mx35pdk.c
> @@ -246,7 +246,7 @@ int board_late_init(void)
>  		mxc_request_iomux(MX35_PIN_COMPARE, MUX_CONFIG_GPIO);
>  		mxc_iomux_set_input(MUX_IN_GPIO1_IN_5, INPUT_CTL_PATH0);
>  
> -		gpio_direction_output(37, 1);
> +		gpio_direction_output(IMX_GPIO_NR(2, 5), 1);
>  	}
>  
>  	val = mc9sdz60_reg_read(MC9SDZ60_REG_GPIO_1) | 0x04;
> 

Sorry for delay.

Applied to u-boot-imx, thanks.

Best regards,
Stefano Babic

-- 
=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de
=====================================================================