Re: [Qemu-devel] [PATCH] e1000: make ICS write-only

[Jason Wang <jasowang@redhat.com>]

On 01/09/2013 06:51 PM, Michael S. Tsirkin wrote:
> Since commit b1332393cdd7d023de8f1f8aa136ee7866a18968,
> qemu started updating ICS register when interrupt
> is sent, with the intent to match spec better
> (guests do not actually read this register).
> However, the function set_interrupt_cause where ICS
> is updated is often called internally by
> device emulation so reading it does not produce the last value
> written by driver.  Looking closer at the spec,
> it documents ICS as write-only, so there's no need
> to update it at all. I conclude that while harmless this line is useless
> code so removing it is a bit cleaner than keeping it in.
>
> Tested with windows and linux guests.
>
> Cc: Bill Paul <wpaul@windriver.com>
> Reported-by: Yan Vugenfirer <yan@daynix.com>
> Signed-off-by: Michael S. Tsirkin <mst@redhat.com>
> ---
>  hw/e1000.c | 1 -
>  1 file changed, 1 deletion(-)
>
> diff --git a/hw/e1000.c b/hw/e1000.c
> index 92fb00a..928d804 100644
> --- a/hw/e1000.c
> +++ b/hw/e1000.c
> @@ -230,7 +230,6 @@ set_interrupt_cause(E1000State *s, int index, uint32_t val)
>          val |= E1000_ICR_INT_ASSERTED;
>      }
>      s->mac_reg[ICR] = val;
> -    s->mac_reg[ICS] = val;
>      qemu_set_irq(s->dev.irq[0], (s->mac_reg[IMS] & s->mac_reg[ICR]) != 0);
>  }
>  

If my memory is correct, though ICS is marked as read only in the spec,
we do can read it when I'm examining a real e1000 card.