From mboxrd@z Thu Jan 1 00:00:00 1970 From: Stefano Babic Date: Wed, 16 Jan 2013 12:24:08 +0100 Subject: [U-Boot] configure USB Host1 in U-Boot of iMx53 In-Reply-To: <2177ED73E324F545904114B93D0026F90139D958@INFHYDEX10MB3.corp.infotech-enterprises.com> References: <2177ED73E324F545904114B93D0026F90139D93E@INFHYDEX10MB3.corp.infotech-enterprises.com> <2177ED73E324F545904114B93D0026F90139D958@INFHYDEX10MB3.corp.infotech-enterprises.com> Message-ID: <50F68DD8.306@denx.de> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de On 16/01/2013 11:49, Sarvesh Gupta wrote: > > Dear All, > > I have added the USB host controller driver into our Mx53 loco board's u-boot and also made some changes in mx53_loco.h and mx53_loco.c. > > Below is the complete log what I am getting on serial console: > > > > U-Boot 2009.08-dirty (Jan 15 2013 - 12:32:20) > CPU: Freescale i.MX53 family 2.1V at 800 MHz > mx53 pll1: 800MHz > mx53 pll2: 400MHz > mx53 pll3: 216MHz > mx53 pll4: 455MHz This ML is intended for U-Boot mainline. However, you are using a version provided and modified by the manufacturer. Ask your support for this, or use u-boot mainline (v2013.01) to post your questions on this mailing list. Best regards, Stefano Babic -- ===================================================================== DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de =====================================================================