Re: [PATCH 04/11] PINCTRL: lantiq: add output pinconf parameter

[John Crispin <blogic@openwrt.org>]

On 05/02/13 15:46, Linus Walleij wrote:
> On Fri, Feb 1, 2013 at 1:04 PM, John Crispin<blogic@openwrt.org>  wrote:
>
>> While converting the boards inside OpenWrt to OF I noticed that the we are
>> missing a pinconf parameter to set a pin to output.
>>
>> Signed-off-by: John Crispin<blogic@openwrt.org>
> OK, I have applied this, BUT:
>
>> @@ -34,6 +34,7 @@ enum ltq_pinconf_param {
>>          LTQ_PINCONF_PARAM_OPEN_DRAIN,
>>          LTQ_PINCONF_PARAM_DRIVE_CURRENT,
>>          LTQ_PINCONF_PARAM_SLEW_RATE,
>> +       LTQ_PINCONF_PARAM_OUTPUT,
>>   };
> All of this exist in the generic pinconf library nowadays.
>
> How about cooking a patch that converts the lantiq driver
> to just use that? It'll be pretty straight forward I think.
>
> I mean you convert it to use the generic pinconf internally,
> the DT representation we'll have to live with.
>
> See for example the new drivers that are boiling in
> -next. All use generic pinconf I think. The parameter to
> set a pin as output was added for the abx500 driver
> this cycle.
>
> Yours,
> Linus Walleij
>
>

Hi,

i'll look into updating the driver to the new api

     John