[U-Boot] [PATCH] mx28evk: Disable CONFIG_CMD_I2C

[Stefano Babic <sbabic@denx.de>]

On 08/03/2013 15:47, Fabio Estevam wrote:
> From: Fabio Estevam <fabio.estevam@freescale.com>
> 
> When loading a Freescale 2.6.35 on a mx28evk the following issue is seen:
> 
> sgtl5000_hw_read: read reg error : Reg 0x00
> Device with ID register 0 is not a SGTL5000
> 
> Disabling CONFIG_CMD_I2C makes the sgtl5000 probe to succeed.
> 
> Mainline kernel does not show this problem.
> 
> Until the real cause is not identified, disable 'CONFIG_CMD_I2C' for the 
> time being.
> 
> Signed-off-by: Fabio Estevam <fabio.estevam@freescale.com>
> ---
> Stefano,
> 
> Since 2013.04 is approaching I prefer to disable this option until the real
> cause is identified.
> 
> This patch applies on top of http://patchwork.ozlabs.org/patch/225950/
> 
>  include/configs/mx28evk.h |    1 -
>  1 file changed, 1 deletion(-)
> 
> diff --git a/include/configs/mx28evk.h b/include/configs/mx28evk.h
> index 9cc236f..cf93ec8 100644
> --- a/include/configs/mx28evk.h
> +++ b/include/configs/mx28evk.h
> @@ -68,7 +68,6 @@
>  #define CONFIG_CMD_SPI
>  #define CONFIG_CMD_USB
>  #define CONFIG_CMD_BOOTZ
> -#define CONFIG_CMD_I2C
>  #define CONFIG_CMD_NAND
>  
>  /*
> 

Applied to u-boot-imx, thanks.

Best regards,
Stefano Babic

-- 
=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de
=====================================================================