[PATCH 4/6] mfd: db8500-prcmu: get base address from resource

[loic.pallardy@st.com (Loic PALLARDY)]

On 03/21/2013 08:07 PM, Arnd Bergmann wrote:
> On Thursday 21 March 2013, Linus Walleij wrote:
>> On Thu, Mar 21, 2013 at 1:15 PM, Arnd Bergmann<arnd@arndb.de>  wrote:
>>
>>> On Thursday 21 March 2013 12:49:11 Linus Walleij wrote:
>>>> -#define PRCM_PLLARM_LOCKP       (_PRCMU_BASE + 0x0a8)
>>>> +#define PRCM_PLLARM_LOCKP       (prcmu_base + 0x0a8)
>>>>   #define PRCM_PLLARM_LOCKP_PRCM_PLLARM_LOCKP3   0x2
>>>
>>> While this is certainly the least invasive way to get rid of _PRCMU_BASE,
>>> it sucks to refer to local variables in macros. How hard would it
>>> be to find all users of these macros and put the prcmu_base addition
>>> there?
>>>
>>> The rest of this patch looks fine to me.
>>
>> Basically I didn't want to disturb Lo?cs work on PRCMU refactoring,
>> but if it is require I can surely do this.
>
> That's probably a good enough reason to leave it alone for now, but we
> should remember to fix it up later.
>
> How about adding a comment in the header so we don't forget about it?
>
I'll prefer to have same way to access all PRCM registers.
prcmu_base should be used only in db8500-prcmu.c file and 
db8500-prcmu-regs.h should contain register offset.
Register should be accessed in db8500-prcmu.c file like:
val = readl(prcmu_base + PRCM_XXX);
Linus, I'll propose you a patch derived from prcmu refactoring stuff.

/Loic

> 	Arnd