Re: [PATCH] spi-gpio: init CS before spi_bitbang_setup()

[Daniel Mack <zonque@gmail.com>]

Cc: Mark

On 09.04.2013 18:40, Josef Ahmad wrote:
> spi_bitbang_setup() deasserts the chip select line to initialise
> the device. The chip select GPIO line is obtained from
> spi_gpio->cs_gpios[] private data.
> Currently, devices that are not registered under devicetree
> environment will call into spi_bitbang_setup() with stale
> cs_gpios[].
> 
> This patch ensures spi_gpio->cs_gpios[] is always initialised prior
> to calling spi_bitbang_setup().
> 
> Reviewed-by: Daniel Mack <zonque@gmail.com>
> Signed-off-by: Josef Ahmad <josef.ahmad@intel.com>
> ---
>  drivers/spi/spi-gpio.c |    2 +-
>  1 files changed, 1 insertions(+), 1 deletions(-)
> 
> diff --git a/drivers/spi/spi-gpio.c b/drivers/spi/spi-gpio.c
> index c7cf0b7..0fa345c 100644
> --- a/drivers/spi/spi-gpio.c
> +++ b/drivers/spi/spi-gpio.c
> @@ -265,9 +265,9 @@ static int spi_gpio_setup(struct spi_device *spi)
>  		}
>  	}
>  	if (!status) {
> -		status = spi_bitbang_setup(spi);
>  		/* in case it was initialized from static board data */
>  		spi_gpio->cs_gpios[spi->chip_select] = cs;
> +		status = spi_bitbang_setup(spi);
>  	}
>  
>  	if (status) {
>