[U-Boot] [PATCH 0/5] vybrid: Add vybrid CPU and vf600 tower board support

[Stefano Babic <sbabic@denx.de>]

On 12/04/2013 08:53, Alison Wang wrote:
> This series contains the support for vybrid CPU and vf600 tower board.
> 
> The Vybrid devices are a family of Freescale's latest Dual Single
> Core offering with ARM Cortex A5 and CM4 based processors for
> Advanced Connected Radio, Entry Infotainment, and Cluster as well
> as high end industrial and general purpose applications.
> 
> 

Hi Alison,

because there is not yet documentation about this family on Freescale's
webiste, could you please mention something more about this processor ?

This helps to better understand where we can put support inside U-Boot.

More or less the following information are very valueable :

- Are there common part (peripheral, controller,..) with other
Freescale's processors ? I doubt there is no point of contact, at least
with i.MX6.

- Which peripheral are reused in this SOC ? I understand in your
patchset that ESDHC is reused, I think also FEC, I wonder that UART is not.

- Which image is produced ? I do not understand why you need a new type
if you reuse the same rule (mkimage for imx) we have.

Best regards,
Stefano Babic



-- 
=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de
=====================================================================