[PATCH] ARM: KVM: iterate over all CPUs for CPU compatibility check

[andre.przywara@linaro.org (Andre Przywara)]

On 04/15/2013 03:48 PM, Will Deacon wrote:
> On Mon, Apr 15, 2013 at 02:13:55PM +0100, Andre Przywara wrote:
>> On 04/15/2013 11:52 AM, Alexander Spyridakis wrote:
>>> I've run on this problem before, while trying to run KVM guests on A7 cores.
>>>
>>> For some reason the 3rd A7 hangs in arch/arm/kvm/init.S, on the
>>> instruction that updates HSCTLR between the two isbs on __do_hyp_init
>>> (mcr p15, 4, r0, c1, c0, 0). If you boot the system with maxcpus=4 then
>>> init_hyp_mode() will not hang on the A7 cluster. Other than that from my
>>> limited testing KVM on A7 works on a usual linux guest. I also tried to
>>> only boot the 3rd A7 core to rule out any racing issues, but still the
>>> same behaviour applies.
>>
>> Could well be the same issue here. I chased it down till CPU 2 goes into
>> HYP mode to do the initialization.
>> I am running with maxcpus=3 (this increases the likelyhood that
>> kvm_target_cpu() runs on an A15), so CPU #2 is the only one A7.
>> As the HYP mode exception table is empty except for the HVC trap, it may
>> be looping here. I am trying now to get the PC of the faulty instruction.
>
> Yes, it sounds like you're taking a recursive fault because the vectors
> aren't installed yet. Is there any chance you can find out what value you end
> up writing (or trying to write) to the HSCTLR please?

Mmh, still thinking about a nice way to get some information out of HYP 
mode. schedule_delayed_work() to monitor a memory address didn't work 
(too early?).

But meanwhile I compared the A7 and A15 TRM 4.3.32 HSCTLR:
Bit 21 is fixed 0 on A15, but fixed 1 on A7.
Can someone confirm that this is not a typo?

Regards,
Andre.