Re: [PATCH] USB: ISP1760: Add flags for interrupt polarity and edge/level trigger

[Alexander Stein <alexander.stein@systec-electronic.com>]

On Tuesday 13 December 2011 10:00:10 Greg KH wrote:
> On Tue, Dec 13, 2011 at 10:33:13AM +0100, Alexander Stein wrote:
> > Signed-off-by: Alexander Stein <alexander.stein@systec-electronic.com>
> > ---
> > 
> >  drivers/usb/host/isp1760-if.c |    4 ++++
> >  include/linux/usb/isp1760.h   |    2 ++
> >  2 files changed, 6 insertions(+), 0 deletions(-)
> > 
> > diff --git a/drivers/usb/host/isp1760-if.c
> > b/drivers/usb/host/isp1760-if.c index a7dc1e1..0ef9867 100644
> > --- a/drivers/usb/host/isp1760-if.c
> > +++ b/drivers/usb/host/isp1760-if.c
> > @@ -388,6 +388,10 @@ static int __devinit isp1760_plat_probe(struct
> > platform_device *pdev)> 
> >  			devflags |= ISP1760_FLAG_DACK_POL_HIGH;
> >  		
> >  		if (priv->dreq_polarity_high)
> >  		
> >  			devflags |= ISP1760_FLAG_DREQ_POL_HIGH;
> > 
> > +		if (priv->interrupt_polarity_high)
> > +			devflags |= ISP1760_FLAG_INTR_POL_HIGH;
> > +		if (priv->interrupt_edge_triggered)
> > +			devflags |= ISP1760_FLAG_INTR_EDGE_TRIG;
> > 
> >  	}
> >  	
> >  	hcd = isp1760_register(mem_res->start, mem_size, irq_res->start,
> > 
> > diff --git a/include/linux/usb/isp1760.h b/include/linux/usb/isp1760.h
> > index de7de53..c5edbc8 100644
> > --- a/include/linux/usb/isp1760.h
> > +++ b/include/linux/usb/isp1760.h
> > @@ -13,6 +13,8 @@ struct isp1760_platform_data {
> > 
> >  	unsigned analog_oc:1;			/* Analog overcurrent */
> >  	unsigned dack_polarity_high:1;		/* DACK active high */
> >  	unsigned dreq_polarity_high:1;		/* DREQ active high */
> > 
> > +	unsigned interrupt_polarity_high:1;
> > +	unsigned interrupt_edge_triggered:1;
> 
> So you added these, and you check them, but who sets them?  What is the
> point of this patch at this point in time?

These platform data bits are set by board configurations, which is completly 
optional. So currently maybe noone sets/use it, but in future someone may need 
it. Also dreq_polarity_high is also there and I only found board files setting 
them to 0... So why not add the feature bits too?

Regards,
Alexander