[U-Boot] [PATCH V2 6/6] arm: mx5: Add support for DENX M53EVK

[Stefano Babic <sbabic@denx.de>]

On 25/04/2013 15:36, Marek Vasut wrote:
> Dear Stefano Babic,
> 

Hi Marek,

>> At least add documentation in the README. It is only your choice if you
>> will add two different targets to boards.cfg
> 
> I'd prefer not to do that. We're currently booting from NAND and SD, so we use 
> u-boot.imx resp. u-boot-with-nand-spl.imx there. But using the BOOT_FROM "nand" 
> in the imximage.cfg is indeed wrong. We should focus on fixing that.
> 
> We can now pre-process the imximage.cfg with CPP, so why don't we just replace 
> BOOT_FROM "foobar" with BOOT_OFFSET CONFIG_IMX_BOOT_OFFSET

+1

> as mentioned by 
> someone in the thread already and setup the offset either in board config file 
> or boards.cfg and even have some default value?

Agree

Best regards,
Stefano

-- 
=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de
=====================================================================