From mboxrd@z Thu Jan 1 00:00:00 1970 From: Ron Croonenberg Date: Tue, 21 May 2013 13:04:58 -0600 Subject: [Lustre-devel] lustre kernel configuration In-Reply-To: <519BB9EA.70304@llnl.gov> References: <5a77f40fe7860376e5bcdfaeb8e6cb7a.squirrel@webmail.andrew.cmu.edu> <20130513213454.GF7378@llnl.gov> <519B8099.7010803@lanl.gov> <519BB9EA.70304@llnl.gov> Message-ID: <519BC55A.4040903@lanl.gov> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: lustre-devel@lists.lustre.org Hi Chris, thanks for the link. What I was looking for was the Linux kernel config but couldn't find any documentation foor (would have been nice to find the ones that are actuallu used in the binaries). Basically what I did is take my RHEL6 config and configured the kernel wit and compiling that seemed to work. (I did compile the rpms, just a regular make. That seemed to work for 1.8.7. I haven't installed anything yet., so we'll see on that part. thanks, Ron On 05/21/2013 12:16 PM, Christopher J. Morrone wrote: > If you use the zfs osd for your servers, there is no need to modify your > Linux kernel. That is probably a much easier way to get started with > Lustre development. > > If you are set on using the ldiskfs osd, Intel has some instructions on > their wiki here: > > https://wiki.hpdd.intel.com/display/PUB/Building+Lustre+from+Source > > Chris > > On 05/21/2013 07:11 AM, Ron Croonenberg wrote: >> hello, >> >> I am looking into some Lustre development but want to build everything >> from scratch. I looked around to see how the linux kernel is configured >> but don't seem to find anything. >> >> any ideas? >> >> thanks, >> >> Ron >> _______________________________________________ >> Lustre-devel mailing list >> Lustre-devel at lists.lustre.org >> http://lists.lustre.org/mailman/listinfo/lustre-devel >> > > _______________________________________________ > Lustre-devel mailing list > Lustre-devel at lists.lustre.org > http://lists.lustre.org/mailman/listinfo/lustre-devel >