Re: [PATCH v2 0/6] Emaclite patches

["Jens Renner (EFE)" <renner@efe-gmbh.de>]

Am 30.05.2013 12:28, schrieb Michal Simek:
> I have separated these emaclite patches from phy patches because it is
> easier for creating new versions.
> 
> Thanks, Michal
> 
> Changes in v2: - Fix __raw_iowrite() to pass correct parameters -
> s/Corrent/Correct/ in patch description
> 
> Michal Simek (6): net: emaclite: Report failures in mdio setup net:
> emaclite: Support multiple phys connected to one MDIO bus net: emaclite:
> Let's make xemaclite_adjust_link static net: emaclite: Do not use
> microblaze and ppc IO functions net: emaclite: Enable emaclite for Xilinx
> Arm Zynq platform net: emaclite: Update driver header
> 
> drivers/net/ethernet/xilinx/Kconfig           |   4 +- 
> drivers/net/ethernet/xilinx/xilinx_emaclite.c | 169
> ++++++++++++++------------ 2 files changed, 95 insertions(+), 78
> deletions(-)

Works without problems on our Microblaze platform (as far as the patches affect
our functionality). MDIO verbosity has been tested ok.

> @@ -862,8 +864,10 @@ static int xemaclite_mdio_setup(struct net_local *lp,
struct device *dev)
> XEL_MDIOCTRL_MDIOEN_MASK);
> 
> bus = mdiobus_alloc(); -	if (!bus) +	if (!bus) { +		dev_err(dev, "Failed to
> allocal mdiobus\n"); return -ENOMEM; +	}
> 
> of_address_to_resource(np, 0, &res); snprintf(bus->id, MII_BUS_ID_SIZE,
> "%.8llx",

Shouldn't the wording be "allocate" instead of "allocal" in PATCH v2 1/6 (net:
emaclite: Report failures in mdio setup)?
Regards
Jens.