Re: Sabrelite Boot

[Eric Nelson <eric.nelson@boundarydevices.com>]

Thanks Daiane,

On 06/18/2013 10:50 AM, Daiane Angolini wrote:
> On 06/18/2013 02:38 PM, Eric Nelson wrote:
>> On 06/18/2013 10:05 AM, Fabio Estevam wrote:
>>> Hi Eric,
>>>
>>> On Tue, Jun 18, 2013 at 1:55 PM, Eric Nelson
>>> <eric.nelson@boundarydevices.com> wrote:
>>>
>>>> I thought this would only take a few minutes, but I did put
>>>> together a U-Boot "Getting started" guide:
>>>>          http://boundarydevices.com/u-boot-on-i-mx6/
>>>>
>>>
>>> Excellent document! Very good work, Eric.
>>>
>>
>> Thanks Fabio,
>>
>> BTW, there's a thread on i.MX Community that I think
>> is misleading:
>>      https://community.freescale.com/docs/DOC-93844
>>
>> Daiane, you indicate that the manufacturing tool works
>> for SABRE Lite, but there's currently no support for
>> the USB OTG port in main-line U-Boot.
>
> Well, I can only say for myself. And I'm always scared when my board
> does not seems to be alive.
>
> In the past, when I was still working with sabrelite. I used mfgtools to
> copy *any* uboot to nor and then make anything needed afterwards.
>

Because the mfgtools uses the serial download protocol, it's likely
that the first stage will work (the piece that downloads U-Boot
into RAM), but the next stage (programming SPI NOR) can only
occur if the U-Boot version supports USB OTG, and main-line
doesn't yet.

Unfortunately, I don't have ready access to a Windows
machine, and it's a pain to test...

> The only think I'm sure. We (meta-fsl-arm) have a problem. Sabrelite
> does not work out of box. It must be fixed someway.
>

I think Otavio's answer is easiest.

> I hope we can find a way that keeps imx6sabrelite.conf file. Because
> several people are working this sabrelite.
>
More than several, I'm sure.

Cheers,


Eric