Re: Missing devtmpfs w/ i.MX6Q SabreSD sato-sdk image

[Daiane Angolini <daiane.angolini@freescale.com>]

On 06/26/2013 01:56 PM, squirem wrote:
> Daiane Angolini <daiane.angolini@...> writes:
>
>> Do you know your board revision and chip TO?
>
> I see the following labels on the board:
> SCH-27516 Rev C1
> 700-27516 Rev A
>
>> Let me bitbake and test core-image-sato-sdk.
> I suspect I may be doing something wrong, the core-image-sato-sdk will
> probably work for you. I'm going to try and build the
> image directly through bitbake, instead of the hob gui, and see what
> happens. This is my build configuration:
>
> Build Configuration:
> BB_VERSION        = "1.18.0"
> BUILD_SYS         = "x86_64-linux"
> NATIVELSBSTRING   = "Fedora-16"
> TARGET_SYS        = "arm-poky-linux-gnueabi"
> MACHINE           = "imx6qsabresd"
> DISTRO            = "poky"
> DISTRO_VERSION    = "1.4"
> TUNE_FEATURES     = "armv7a vfp neon"
> TARGET_FPU        = "vfp-neon"
> meta
> meta-yocto
> meta-yocto-bsp
> meta-hob
> meta-fsl-arm-dylan = "<unknown>:<unknown>"
>
> Here is how the meta-fsl-arm layer was added in my bblayers.conf file:
> #added by bitbake
> BBLAYERS = "/home/squirem/Desktop/poky-dylan-9.0.0/meta \
> /home/squirem/Desktop/poky-dylan-9.0.0/meta-yocto \
> /home/squirem/Desktop/poky-dylan-9.0.0/meta-yocto-bsp \
> /home/squirem/Desktop/poky-dylan-9.0.0/meta-hob \
> /home/squirem/Desktop/poky-dylan-9.0.0/meta-fsl-arm-dylan"
>
> May I ask what steps you take in building the image?

Sure:

I follow the steps from
https://github.com/Freescale/fsl-community-bsp-platform


$ ./repo init -u https://github.com/Freescale/fsl-community-bsp-platform 
-b dylan
$ ./repo sync
$ source ./setup-environment build
$ MACHINE="imx6qsabresd" bitbake core-image-minimal


I'm not used with HOB, in fact...


-- 
Daiane