Re: [PATCH] mmc: omap_hsmmc: use for OMAP5 as well

[Balaji T K <balajitk@ti.com>]

On Friday 28 June 2013 06:04 PM, a-bindra@ti.com wrote:
> From: Amarinder Bindra <a-bindra@ti.com>
>
> OMAP's hs_mmc driver is also used for OMAP5 MMC controller operation.
> Considering that the device tree entries are already there for this,
> allow the driver to be built when only OMAP5 is enabled.
> This allows MMC root filesystems to be available in "OMAP5 only"
> configurations.
>
> Signed-off-by: Amarinder Bindra <a-bindra@ti.com>
> Acked-by: Felipe Balbi <balbi@ti.com>
> Acked-by: Nishanth Menon <nm@ti.com>

Looks good to me,
Acked-by: Balaji T K <balajitk@ti.com>

> ---
>   drivers/mmc/host/Kconfig |    6 +++---
>   1 file changed, 3 insertions(+), 3 deletions(-)
>
> diff --git a/drivers/mmc/host/Kconfig b/drivers/mmc/host/Kconfig
> index 009dabd..6722e21 100644
> --- a/drivers/mmc/host/Kconfig
> +++ b/drivers/mmc/host/Kconfig
> @@ -254,11 +254,11 @@ config MMC_OMAP
>
>   config MMC_OMAP_HS
>   	tristate "TI OMAP High Speed Multimedia Card Interface support"
> -	depends on SOC_OMAP2430 || ARCH_OMAP3 || ARCH_OMAP4
> +	depends on SOC_OMAP2430 || ARCH_OMAP3 || ARCH_OMAP4 || SOC_OMAP5
>   	help
>   	  This selects the TI OMAP High Speed Multimedia card Interface.
> -	  If you have an OMAP2430 or OMAP3 board or OMAP4 board with a
> -	  Multimedia Card slot, say Y or M here.
> +	  If you have an OMAP2430 or OMAP3 board or OMAP4 board or OMAP5
> +	  board with a Multimedia Card slot, say Y or M here.
>
>   	  If unsure, say N.
>
>