Re: [PATCH] usb: musb: am335x: Do not remove the session bin HOST-only mode

[Sergei Shtylyov <sergei.shtylyov@cogentembedded.com>]

Hello.

On 08/09/2013 08:03 PM, Sebastian Andrzej Siewior wrote:

> This is what I observe:
> On the first connect, the musb starts with DEVCTL.Session set. On
> disconnect, musb_core calls try_idle. That functions removes the Session
> bit signalize that the session is over (something that only in OTG is
> required). A new device, that is plugged, is no longer recognized.
> I've setup a timer and checked the DEVCTL register and I haven't seen a
> change in VBus and I saw the B-Device bit set. After setting the IDDIG
> into A mode and forcing the device to behave like I didn't see a change.
> Neither VBUS goes to 0b11 nor does a session start request come.
> The TI-v3.2 kernel they skip to call musb_platform_try_idle() in the
> OTG_STATE_A_WAIT_BCON state while not in OTG mode.
> Since the second port hast a standard A plug the patch changes the port
> to run in host mode only, force the id-pin to host only and skip the
> timer which would remove DEVCTL.Session.

> Signed-off-by: Sebastian Andrzej Siewior <bigeasy@linutronix.de>
[...]

> diff --git a/drivers/usb/musb/musb_dsps.c b/drivers/usb/musb/musb_dsps.c
> index 4ffbaac..b0752fa 100644
> --- a/drivers/usb/musb/musb_dsps.c
> +++ b/drivers/usb/musb/musb_dsps.c
[...]
> @@ -388,6 +393,14 @@ static int dsps_musb_init(struct musb *musb)
>   	val &= ~(1 << wrp->otg_disable);
>   	dsps_writel(musb->ctrl_base, wrp->phy_utmi, val);
>
> +	if (musb->port_mode == MUSB_PORT_MODE_HOST) {
> +		val = USBMODE_IDDIG_A;
> +		val |= USBMODE_ID_MUX_REG;

    Why not do the above in one line and save on {} {}? It will look more 
aesthetically pleasing IMHO.

> +	} else {
> +		val = USBMODE_ID_MUX_PHY;
> +	}
> +	dsps_writel(musb->ctrl_base, wrp->mode, val);
> +

WBR, Sergei