Re: [Qemu-devel] in_asm substitute for accel=kvm:tcg

[Andriy Gapon <avg@FreeBSD.org>]

on 19/09/2013 20:26 Paolo Bonzini said the following:
> I don't think that's what happens.  It's more likely that for some
> reason the emulator mis-parses the instruction.
> 
> Please confirm with "info cpus" that QEMU is looping there (just in
> case), and attach the output of "info registers" (you can use "-monitor
> stdio" to do this and to answer question 2 from my previous email).

(qemu) info registers
EAX=00000010 EBX=00009335 ECX=00000000 EDX=00000000
ESI=000017fc EDI=000017c8 EBP=00045400 ESP=000017b8
EIP=00009315 EFL=00003002 [-------] CPL=3 II=0 A20=1 SMM=0 HLT=0
ES =0000 00000000 ffffffff 00c09300
CS =0000 00000000 0000ffff 0000f300
SS =0000 00000000 0000ffff 0000f300
DS =0000 00000000 ffffffff 00c09300
FS =0a00 0000a000 ffffffff 00c0f300
GS =0a00 0000a000 ffffffff 00c0f300
LDT=0000 00000000 0000ffff 00008200
TR =0038 00005f98 00002067 00008b00
GDT=     00009590 0000003f
IDT=     00005e00 00000197
CR0=00000010 CR2=00000000 CR3=00000000 CR4=00000000
DR0=0000000000000000 DR1=0000000000000000 DR2=0000000000000000 DR3=0000000000000000
DR6=00000000ffff0ff0 DR7=0000000000000400
EFER=0000000000000000
FCW=037f FSW=0000 [ST=0] FTW=00 MXCSR=00001f80
FPR0=0000000000000000 0000 FPR1=0000000000000000 0000
FPR2=0000000000000000 0000 FPR3=0000000000000000 0000
FPR4=0000000000000000 0000 FPR5=0000000000000000 0000
FPR6=0000000000000000 0000 FPR7=0000000000000000 0000
XMM00=00000000000000000000000000000000 XMM01=00000000000000000000000000000000
XMM02=00000000000000000000000000000000 XMM03=00000000000000000000000000000000
XMM04=00000000000000000000000000000000 XMM05=00000000000000000000000000000000
XMM06=00000000000000000000000000000000 XMM07=00000000000000000000000000000000

(qemu) info cpus
* CPU #0: pc=0x0000000000009315 thread_id=17463

But I can't 100% guarantee validity of these results.
It seems that the first time I execute any monitor command it reports something
consistently, but all subsequent invocations produce something different.
So I restart the guest two times and each of the above commands was executes as
the first command in monitor.

-- 
Andriy Gapon