From mboxrd@z Thu Jan 1 00:00:00 1970 From: Bernd Schubert Subject: Re: SCSI's heuristics for enabling WRITE SAME still need work [was: dm mpath: disable WRITE SAME if it fails] Date: Wed, 25 Sep 2013 22:52:28 +0200 Message-ID: <52434D0C.1090008@fastmail.fm> References: <20130919161043.GA27081@redhat.com> <20130920212142.GA17898@redhat.com> <1379960325.4010.32.camel@localhost.localdomain> <52412581.2010909@suse.de> <20130924123449.GA16083@redhat.com> Mime-Version: 1.0 Content-Type: text/plain; charset=ISO-8859-1 Content-Transfer-Encoding: 7bit Return-path: In-Reply-To: Sender: linux-scsi-owner@vger.kernel.org To: "Martin K. Petersen" Cc: Mike Snitzer , Hannes Reinecke , emilne@redhat.com, device-mapper development , dgilbert@interlog.com, linux-scsi@vger.kernel.org List-Id: dm-devel.ids On 09/24/2013 03:49 PM, Martin K. Petersen wrote: >>>>>> "Mike" == Mike Snitzer writes: > > Mike> So are there drives like this?: > Mike> 1) don't support RSOC > Mike> 2) do support WRITE SAME > Mike> 3) do populate VPD page with either WRITE SAME w/ discard bit set > Mike> or UNMAP? > > Yes. > > But again, the fundamental issue here is not the drives. It's the > controller firmware. I am not aware of a single SPI/SAS/FC drive that > does not support at least WRITE SAME(10). > > For DIX and T10 PI I have a capabilities mask that each HBA driver fills > out that tells the sd driver what the controller can do. And this is > combined with whatever the drive reports to figure out whether integrity > protection can be enabled. > > I have been contemplating doing something similar for "fancy" SCSI > commands. We could have a flag in the scsi host template that controls > whether the device supports WRITE SAME, EXTENDED COPY, etc. The > advantage being that we do the matching at discovery time instead of > once a WRITE SAME is issued. > > This would also permit HBA drivers to toggle the feature on a per > instance basis. I.e. if "RAID controller firmware rev is lower than XYZ, > do not support WRITE SAME". > > I'll do a PoC later today... > Martin, I'm afraid we have another problem. I'm currently working on to get discard working for our LSI2008 HBAs with attached sata-SSDs and the heuristics in sd_read_write_same with based on VPD page 0x89 is not correct for this HBA - its SATL supports write-same (although it does "Logical block address out of range" at the end of the device, I'm going to look into this tomorrow). So allow LSI SATL or remove this check at all? Thanks, Bernd