Re: [PATCH 5/7] net: of_mdio: parse "max-speed" property to set PHY supported features

[Rob Herring <robherring2@gmail.com>]

On 12/05/2013 04:52 PM, Florian Fainelli wrote:
> From: Florian Fainelli <f.fainelli@gmail.com>
> 
> The "max-speed" property is defined per the ePAPR specification to
> express the maximum speed a PHY supports. Use that property, if present
> to set the phydev->supported features which properly restricts the PHY
> within the range of defined speeds.
> 
> Signed-off-by: Florian Fainelli <f.fainelli@gmail.com>
> ---
>  drivers/of/of_mdio.c | 25 ++++++++++++++++++++++++-
>  1 file changed, 24 insertions(+), 1 deletion(-)
> 
> diff --git a/drivers/of/of_mdio.c b/drivers/of/of_mdio.c
> index 4923ab2..e1e19e5 100644
> --- a/drivers/of/of_mdio.c
> +++ b/drivers/of/of_mdio.c
> @@ -22,12 +22,30 @@
>  MODULE_AUTHOR("Grant Likely <grant.likely@secretlab.ca>");
>  MODULE_LICENSE("GPL");
>  
> +static void of_set_phy_supported(struct phy_device *phydev, u32 max_speed)
> +{
> +	phydev->supported |= PHY_DEFAULT_FEATURES;
> +
> +	switch (max_speed) {
> +	default:
> +		return;
> +
> +	case SPEED_1000:
> +		phydev->supported |= PHY_1000BT_FEATURES;

This assumes the speed is not already set. Do you need to first mask
speeds out?

No need to support 10G PHYs?

A fall-thru note would be helpful here.

> +	case SPEED_100:
> +		phydev->supported |= PHY_100BT_FEATURES;
> +	case SPEED_10:
> +		phydev->supported |= PHY_10BT_FEATURES;
> +	}
> +}
> +
>  static int of_mdiobus_register_phy(struct mii_bus *mdio, struct device_node *child,
>  				   u32 addr)
>  {
>  	struct phy_device *phy;
>  	bool is_c45;
>  	int rc, prev_irq;
> +	u32 max_speed = 0;
>  
>  	is_c45 = of_device_is_compatible(child,
>  					 "ethernet-phy-ieee802.3-c45");
> @@ -58,8 +76,13 @@ static int of_mdiobus_register_phy(struct mii_bus *mdio, struct device_node *chi
>  		return 1;
>  	}
>  
> +	/* Set phydev->supported based on the "max-speed" property
> +	 * if present */
> +	if (!of_property_read_u32(child, "max-speed", &max_speed))
> +		of_set_phy_supported(phy, max_speed);
> +
>  	dev_dbg(&mdio->dev, "registered phy %s at address %i\n",
> -		 child->name, addr);
> +		child->name, addr);
>  
>  	return 0;
>  }
>