Re: [PATCH] powerpc: set default kernel thread priority to medium-low

[Philippe Bergheaud <felix@linux.vnet.ibm.com>]

Benjamin Herrenschmidt wrote:
> On Wed, 2013-12-11 at 17:29 +1100, Michael Ellerman wrote:
> 
> 
>>It would be nice if you could make an assertion about what the state of HMT
>>handling should be once your patch is applied.
>>
>>I think it's:
>>
>> * The kernel should use HMT_MEDIUM_LOW as it's "default" priority
>> * The kernel should use HMT_LOW as it's "low" priority
>>
>>Which would imply:
>>
>> * The kernel should not use HMT_MEDIUM anywhere ..
>> * Nor should it use any of the other higher HMT modes.
>>
>>Do you agree?
Not entirely.  HT_MEDIUM might still be used by the kernel, in places where a priority higher than the default is required.
>>The reason I ask is I still see HMT_MEDIUM used in a few places, and it's not
>>clear to me if that is correct.
> 
> 
> HMT_MEDIUM used to be our default no ?
Yes, but I am not sure that all references to HMT_MEDIUM were references to the default kernel priority.
> Also there's an open question... when doing things with interrupts off
> (or worse, in real mode) such as some KVM hcalls etc... should we on the
> contrary boost up to limit interrupt latency ?
Yes. I think that there are cases when one should consider using HT_MEDIUM.

Shouldn't we define a new macro HMT_DEFAULT, to identify explicitely where the default priority is required?

Philippe