[U-Boot] [PATCH] mmc: Minor cleanup of sdhci.c

[Jaehoon Chung <jh80.chung@samsung.com>]

Hi, Darwin.

I didn't think that "__func__" is needs...in my case.
There isn't the duplicated message, anywhere.

Best Regards,
Jaehoon Chung

On 12/20/2013 08:13 AM, Darwin Rambo wrote:
> Fixup prints to show where the print is done from, and
> a few minor formatting/grammar issues.
> 
> Signed-off-by: Darwin Rambo <drambo@broadcom.com>
> ---
>  drivers/mmc/sdhci.c |   32 +++++++++++++++++++-------------
>  1 file changed, 19 insertions(+), 13 deletions(-)
> 
> diff --git a/drivers/mmc/sdhci.c b/drivers/mmc/sdhci.c
> index 46ae9cb..1e86b92 100644
> --- a/drivers/mmc/sdhci.c
> +++ b/drivers/mmc/sdhci.c
> @@ -24,7 +24,8 @@ static void sdhci_reset(struct sdhci_host *host, u8 mask)
>  	sdhci_writeb(host, mask, SDHCI_SOFTWARE_RESET);
>  	while (sdhci_readb(host, SDHCI_SOFTWARE_RESET) & mask) {
>  		if (timeout == 0) {
> -			printf("Reset 0x%x never completed.\n", (int)mask);
> +			printf("%s: Reset 0x%x never completed.\n",
> +			       __func__, (int)mask);
>  			return;
>  		}
>  		timeout--;
> @@ -79,7 +80,8 @@ static int sdhci_transfer_data(struct sdhci_host *host, struct mmc_data *data,
>  	do {
>  		stat = sdhci_readl(host, SDHCI_INT_STATUS);
>  		if (stat & SDHCI_INT_ERROR) {
> -			printf("Error detected in status(0x%X)!\n", stat);
> +			printf("%s: Error detected in status(0x%X)!\n",
> +			       __func__, stat);
>  			return -1;
>  		}
>  		if (stat & rdy) {
> @@ -102,7 +104,7 @@ static int sdhci_transfer_data(struct sdhci_host *host, struct mmc_data *data,
>  		if (timeout-- > 0)
>  			udelay(10);
>  		else {
> -			printf("Transfer data timeout\n");
> +			printf("%s: Transfer data timeout\n", __func__);
>  			return -1;
>  		}
>  	} while (!(stat & SDHCI_INT_DATA_END));
> @@ -147,7 +149,7 @@ int sdhci_send_command(struct mmc *mmc, struct mmc_cmd *cmd,
>  
>  	while (sdhci_readl(host, SDHCI_PRESENT_STATE) & mask) {
>  		if (time >= cmd_timeout) {
> -			printf("MMC: %d busy ", mmc_dev);
> +			printf("%s: MMC: %d busy ", __func__, mmc_dev);
>  			if (2 * cmd_timeout <= CONFIG_SDHCI_CMD_MAX_TIMEOUT) {
>  				cmd_timeout += cmd_timeout;
>  				printf("timeout increasing to: %u ms.\n",
> @@ -179,7 +181,7 @@ int sdhci_send_command(struct mmc *mmc, struct mmc_cmd *cmd,
>  	if (data)
>  		flags |= SDHCI_CMD_DATA;
>  
> -	/*Set Transfer mode regarding to data flag*/
> +	/* Set Transfer mode regarding to data flag */
>  	if (data != 0) {
>  		sdhci_writeb(host, 0xe, SDHCI_TIMEOUT_CONTROL);
>  		mode = SDHCI_TRNS_BLK_CNT_EN;
> @@ -230,7 +232,7 @@ int sdhci_send_command(struct mmc *mmc, struct mmc_cmd *cmd,
>  		if (host->quirks & SDHCI_QUIRK_BROKEN_R1B)
>  			return 0;
>  		else {
> -			printf("Timeout for status update!\n");
> +			printf("%s: Timeout for status update!\n", __func__);
>  			return TIMEOUT;
>  		}
>  	}
> @@ -307,7 +309,8 @@ static int sdhci_set_clock(struct mmc *mmc, unsigned int clock)
>  	while (!((clk = sdhci_readw(host, SDHCI_CLOCK_CONTROL))
>  		& SDHCI_CLOCK_INT_STABLE)) {
>  		if (timeout == 0) {
> -			printf("Internal clock never stabilised.\n");
> +			printf("%s: Internal clock never stabilised.\n",
> +			       __func__);
>  			return -1;
>  		}
>  		timeout--;
> @@ -397,7 +400,8 @@ int sdhci_init(struct mmc *mmc)
>  	if ((host->quirks & SDHCI_QUIRK_32BIT_DMA_ADDR) && !aligned_buffer) {
>  		aligned_buffer = memalign(8, 512*1024);
>  		if (!aligned_buffer) {
> -			printf("Aligned buffer alloc failed!!!");
> +			printf("%s: Aligned buffer alloc failed!!!\n",
> +			       __func__);
>  			return -1;
>  		}
>  	}
> @@ -418,8 +422,8 @@ int sdhci_init(struct mmc *mmc)
>  	}
>  
>  	/* Enable only interrupts served by the SD controller */
> -	sdhci_writel(host, SDHCI_INT_DATA_MASK | SDHCI_INT_CMD_MASK
> -		     , SDHCI_INT_ENABLE);
> +	sdhci_writel(host, SDHCI_INT_DATA_MASK | SDHCI_INT_CMD_MASK,
> +		     SDHCI_INT_ENABLE);
>  	/* Mask all sdhci interrupt sources */
>  	sdhci_writel(host, 0x0, SDHCI_SIGNAL_ENABLE);
>  
> @@ -433,7 +437,7 @@ int add_sdhci(struct sdhci_host *host, u32 max_clk, u32 min_clk)
>  
>  	mmc = malloc(sizeof(struct mmc));
>  	if (!mmc) {
> -		printf("mmc malloc fail!\n");
> +		printf("%s: mmc malloc fail!\n", __func__);
>  		return -1;
>  	}
>  
> @@ -450,7 +454,8 @@ int add_sdhci(struct sdhci_host *host, u32 max_clk, u32 min_clk)
>  	caps = sdhci_readl(host, SDHCI_CAPABILITIES);
>  #ifdef CONFIG_MMC_SDMA
>  	if (!(caps & SDHCI_CAN_DO_SDMA)) {
> -		printf("Your controller don't support sdma!!\n");
> +		printf("%s: Your controller doesn't support SDMA!!\n",
> +		       __func__);
>  		return -1;
>  	}
>  #endif
> @@ -467,7 +472,8 @@ int add_sdhci(struct sdhci_host *host, u32 max_clk, u32 min_clk)
>  		mmc->f_max *= 1000000;
>  	}
>  	if (mmc->f_max == 0) {
> -		printf("Hardware doesn't specify base clock frequency\n");
> +		printf("%s: Hardware doesn't specify base clock frequency\n",
> +		       __func__);
>  		return -1;
>  	}
>  	if (min_clk)
>