[ath9k-devel] ath: phy0: unsupported hw bitrate detected 0x1b using 1 Mbit

[Oleksij Rempel <linux@rempel-privat.de>]

Am 08.01.2014 12:18, schrieb Sujith Manoharan:
> Sujith Manoharan wrote:
>>> seems to be fixed with this change. thank you :)
>>
>> Thanks for testing, I'll post a more complete patch.
> 
> Just to confirm, can you test this patch on a clean tree
> (without the earlier fix) and make sure that the debug message
> is seen when the issue happens ?
> 
> Thanks !
> 
> diff --git a/drivers/net/wireless/ath/ath9k/recv.c b/drivers/net/wireless/ath/ath9k/recv.c
> index 6d643ca..c1486d4 100644
> --- a/drivers/net/wireless/ath/ath9k/recv.c
> +++ b/drivers/net/wireless/ath/ath9k/recv.c
> @@ -854,6 +854,13 @@ static int ath9k_process_rate(struct ath_common *common,
>  	band = hw->conf.chandef.chan->band;
>  	sband = hw->wiphy->bands[band];
>  
> +	if (hw->conf.chandef.chan->band != sc->sc_ah->curchan->chan->band) {
> +		ath_dbg(common, ANY,
> +			"Band/channel mismatch (%d, %d)\n",
> +			hw->conf.chandef.chan->band,
> +			sc->sc_ah->curchan->chan->band);
> +	}
> +
>  	switch (hw->conf.chandef.width) {
>  	case NL80211_CHAN_WIDTH_5:
>  		rxs->flag |= RX_FLAG_5MHZ;


If you still need this test result:
[  222.222983] ath: phy0: Band/channel mismatch (0, 1)

-- 
Regards,
Oleksij