Re: [PATCH 00/04] PCI: rcar: Driver model and physical address space update

[Ben Dooks <ben.dooks@codethink.co.uk>]

On 05/02/14 06:52, Magnus Damm wrote:
> PCI: rcar: Driver model and physical address space update
>
> [PATCH 01/04] PCI: rcar: Register each instance independently
> [PATCH 02/04] PCI: rcar: Break out window size handling
> [PATCH 03/04] PCI: rcar: Add DMABOUNCE support
> [PATCH 04/04] PCI: rcar: Enable BOUNCE in case of HIGHMEM
>
> These patches update the pci-rcar-gen2.c driver in various ways
> including cleanups for driver model interface (1/4), readability
> update (2/4) and also bounce buffer support (3/4, 4/4). Basically
> the first two are just cleanups and the rest are fixes.
>
> As it is today without these patches the system memory start address
> is hard coded at 0x4000000 and the window is fixed at 1GiB. So we
> have board specific code hidden in the driver which is good to avoid.
>
> With these hard coded board specific constants there are some error cases
> that are not handled, in particular the issue that only maximum 1GiB of
> physical address space can be used for bus mastering with a single window.
> The common case of using ARM CONFIG_VMSPLIT_3G results in no visible issues
> as long as CONFIG_BOUNCE is used, but other CONFIG_VMSPLIT settings will
> break due to the hard coded 1GiB window not being enough. It has been
> verified that reducing the window size to 256MB makes the driver behave
> the same with VMSPLIT_3G as 1GiB window size and other VMSPLIT settings.
>
> To handle the maximum 1GiB physical address space limitation two types
> of bounce buffers are added. The ARM specific DMABOUNCE code is in 3/4
> hooked up to a chunk of local memory that is also handed of as coherent
> memory to the pci devices hanging off the PCI bridge. The driver makes
> sure to set the window so the local memory is always included. When the
> PCI devices are operating and in case memory is used outside the window
> then the DMABOUNCE buffers kicks in. This makes the driver support all
> kinds of VMSPLIT settings and window sizes. The BOUNCE code in 4/4 is
> selected to make sure bounce buffers are used for HIGHMEM.
>
> With these patches this driver can be used with or without CMA and
> with or without DMA zone. Basically the system wide memory setup is
> left to the user. If a DMA zone is used then the PCI window will
> be setup to cover that. Same thing with CMA.
>
> Tested with USB storage using LPAE and various VMSPLIT settings together
> with renesas git tag renesas-devel-v3.14-rc1-20140204 from kernel.org

Ok, is it possible to build a set with my of updates ready for next
merge window? I can update the set based on this if you like and try
and make the necessary changes to deal with the modifications from this
series.

-- 
Ben Dooks				http://www.codethink.co.uk/
Senior Engineer				Codethink - Providing Genius