[U-Boot] [PATCH] ENGR00299356 ARM:imx6 Fix USDHC driver bug in PIO mode

[Stefano Babic <sbabic@denx.de>]

Hi Ye.Li,

On 19/02/2014 11:33, Ye.Li wrote:
> When configure the USDHC driver to PIO mode by defining
> "CONFIG_SYS_FSL_ESDHC_USE_PIO", the SD/MMC read and write will fail.
> 
> Two bugs in the driver to cause the issue:
> 1. The read buffer was invalidated after reading from DATAPORT register,
> which should be only applied to DMA mode. The valid data in cache was
> overwritten by physical memory.
> 2. The watermarks are not set in PIO mode, will cause according state not
> be set.
> 
> Signed-off-by: Ye.Li <B37916@freescale.com>
> ---

Why is this an  ARM/i.MX6 issue only ? As far as I read, this is not
strictly related to the SOC. Currently, there is no ARM boards setting
CONFIG_SYS_FSL_ESDHC_USE_PIO. The only boards using it are PowerPC
boards (the driver is platform independent): P1_P2_RDB and MPC8308RDB.

Regards,
Stefano Babic

-- 
=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de
=====================================================================