[PATCH net] eth: fec: Fix lost promiscuous mode after reconnecting cable

[Stefan Wahren <stefan.wahren@i2se.com>]

If the Freescale i.MX28 fec is in promiscuous mode and network cable is
reconnected then the promiscuous mode get lost. The problem is caused
by a too soon call of set_multicast_list to re-enable promisc mode.
The FEC_R_CNTRL register changes are overwritten by fec_restart.

This patch fixes this by moving the call behind the init of FEC_R_CNTRL
register in fec_restart.

Successful tested on a i.MX28 board.

Signed-off-by: Stefan Wahren <stefan.wahren@i2se.com>
---
 drivers/net/ethernet/freescale/fec_main.c |   14 +++++++-------
 1 file changed, 7 insertions(+), 7 deletions(-)

diff --git a/drivers/net/ethernet/freescale/fec_main.c
b/drivers/net/ethernet/freescale/fec_main.c
index 479a7cb..03a3513 100644
--- a/drivers/net/ethernet/freescale/fec_main.c
+++ b/drivers/net/ethernet/freescale/fec_main.c
@@ -528,13 +528,6 @@ fec_restart(struct net_device *ndev, int duplex)
     /* Clear any outstanding interrupt. */
     writel(0xffc00000, fep->hwp + FEC_IEVENT);
 
-    /* Setup multicast filter. */
-    set_multicast_list(ndev);
-#ifndef CONFIG_M5272
-    writel(0, fep->hwp + FEC_HASH_TABLE_HIGH);
-    writel(0, fep->hwp + FEC_HASH_TABLE_LOW);
-#endif
-
     /* Set maximum receive buffer size. */
     writel(PKT_MAXBLR_SIZE, fep->hwp + FEC_R_BUFF_SIZE);
 
@@ -655,6 +648,13 @@ fec_restart(struct net_device *ndev, int duplex)
 
     writel(rcntl, fep->hwp + FEC_R_CNTRL);
 
+    /* Setup multicast filter. */
+    set_multicast_list(ndev);
+#ifndef CONFIG_M5272
+    writel(0, fep->hwp + FEC_HASH_TABLE_HIGH);
+    writel(0, fep->hwp + FEC_HASH_TABLE_LOW);
+#endif
+
     if (id_entry->driver_data & FEC_QUIRK_ENET_MAC) {
         /* enable ENET endian swap */
         ecntl |= (1 << 8);
-- 
1.7.10.4