[U-Boot] [PATCH 1/2] arm: mxs: Adjust the load address of U-Boot and SPL for HAB

[Stefano Babic <sbabic@denx.de>]

On 05/03/2014 20:01, Marek Vasut wrote:
> When using HAB, there are additional special requirements on the placement of
> U-Boot and the U-Boot SPL in memory. To fullfill these, this patch moves the
> U-Boot binary a little further from the begining of the DRAM, so the HAB CST
> and IVT can be placed in front of the U-Boot binary. This is necessary, since
> both the U-Boot and the IVT must be contained in single CST signature. To
> make things worse, the IVT must be concatenated with one more entry at it's
> end, that is the length of the entire CST signature, IVT and U-Boot binary
> in memory. By placing the blocks in this order -- CST, IVT, U-Boot, we can
> easily align them all and then produce the length field as needed.
> 
> As for the SPL, on i.MX23/i.MX28, the SPL size is limited to 32 KiB, thus
> we place the IVT at 0x8000 offset, CST right past IVT and claim the size
> is correct. The HAB library accepts this setup.
> 
> Finally, to make sure the vectoring in SPL still works even after moving
> the SPL from 0x0 to 0x1000, we add a small function which copies the
> vectoring code and tables to 0x0. This is fine, since the vectoring code
> is position independent.
> 
> Signed-off-by: Marek Vasut <marex@denx.de>
> Cc: Stefano Babic <sbabic@denx.de>
> ---

Applied to u-boot-imx, thanks !

Best regards,
Stefano Babic

-- 
=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de
=====================================================================