Re: [PATCH v3] bonding: Inactive slaves should keep inactive flag's value

["zheng.li" <zheng.x.li@oracle.com>]

Hi Jay,
How do you think about the new patch used USES_PRIMARY, can it be merged
to upstream?

Thanks,
Zheng Li


于 2014年04月02日 11:01, Zheng Li 写道:
> bond_open is not setting the inactive flag correctly for some modes (alb and
> tlb), resulting in error behavior if the bond has been administratively set
> down and then back up. This effect should not occur when slaves are added while
> the bond is up; it's something that only happens after a down/up bounce of the
> bond.
> 
> For example, in bond tlb or alb mode, domu send some ARP request which go out
> from dom0 bond's active slave, then the ARP broadcast request packets go back to
> inactive slave from switch, because the inactive slave's inactive flag is zero,
> kernel will receive the packets and pass them to bridge that cause dom0's bridge
> map domu's MAC address to port of bond, bridge should map domu's MAC to port of
> vif.
> 
> Signed-off-by: Zheng Li <zheng.x.li@oracle.com>
> Signed-off-by: Jay Vosburgh <j.vosburgh@gmail.com>
> ---
>  drivers/net/bonding/bond_main.c |    2 +-
>  1 files changed, 1 insertions(+), 1 deletions(-)
> 
> diff --git a/drivers/net/bonding/bond_main.c b/drivers/net/bonding/bond_main.c
> index e5628fc..b42758f 100644
> --- a/drivers/net/bonding/bond_main.c
> +++ b/drivers/net/bonding/bond_main.c
> @@ -3058,7 +3058,7 @@ static int bond_open(struct net_device *bond_dev)
>  	if (bond_has_slaves(bond)) {
>  		read_lock(&bond->curr_slave_lock);
>  		bond_for_each_slave(bond, slave, iter) {
> -			if ((bond->params.mode == BOND_MODE_ACTIVEBACKUP)
> +			if (USES_PRIMARY(bond->params.mode)
>  				&& (slave != bond->curr_active_slave)) {
>  				bond_set_slave_inactive_flags(slave,
>  							      BOND_SLAVE_NOTIFY_NOW);
>